The main body ECU (multiplex network body ECU) controls the instrument panel ambient illumination light (instrument panel light assembly).
Inspect the fuses for circuits related to this system before performing the following procedure.
Before replacing the main body ECU (multiplex network body ECU), refer to Service Bulletin.
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / Main Body / Active Test.
Perform the Active Test according to the display on the GTS.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Interior Illumination Light1 | Instrument panel ambient illumination light (Instrument panel light assembly) | OFF or ON | Preconditions for using the Active Test to check dimmer controlled illumination:
·
Power switch on (IG) ·
Shift lever is in any position other than P |
| Tester Display |
|---|
| Interior Illumination Light1 |
Instrument panel ambient illumination light comes on.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG
Remove the instrument panel ambient illumination light (instrument panel light assembly).
Click hereVehicle Interior>LIGHTING (INT)>AMBIENT LIGHT>REMOVAL
Inspect the instrument panel ambient illumination light (instrument panel light assembly).
Click hereVehicle Interior>LIGHTING (INT)>AMBIENT LIGHT>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the 3G instrument panel junction block assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3G-1 - Body ground | Power switch off | 11 to 14 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Component without harness connected
(Instrument Panel Junction Block Assembly) |
- | - |
Disconnect the 3B instrument panel junction block assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3B-24 - 3G-1 | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3B-24 - K89-2 (B) | Always | Below 1 Ω |
| 3B-24 or K89-2 (B) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the K53 main body ECU (multiplex network body ECU) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| K89-1 (E) - K53-20 (LED1) | Always | Below 1 Ω |
| K89-1 (E) or K53-20 (LED1) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG