Home › Vehicle Exterior › LIGHTING (EXT) › SWITCH HOUSING
RM33C0E _59 Vehicle Exterior _065472 LIGHTING (EXT) _0330503 SWITCH HOUSING A

LIGHTING (EXT)  SWITCH HOUSING  INSTALLATION  


PROCEDURE

Hide 84319 1.INSTALL STEERING WHEEL SWITCH HOUSING

a.

When reusing the steering wheel switch housing:

i.
E365648

Using pliers, expand the clamp and temporarily install the steering wheel switch housing as shown in the illustration.


ii.
E365650C01
0,0 0,0 false
V113147

Engage in this Direction


While holding the clamp expanded, engage the claw as shown in the illustration.


iii.
E365651

Release the clamp to install the steering wheel switch housing as shown in the illustration.



b.

When installing a new steering wheel switch housing:

i.
E365652

Temporarily install the steering wheel switch housing.


ii.
E365653C01
0,0 0,0 false
V113147

Install in this Direction


Engage the claw as shown in the illustration.


iii.
E365654C01
1.292,0.542 1.656,0.51 true 1.063,0.458 1.375,0.615 0.313,0.156 10 true *a
*a Pin
V113147

Remove in this Direction


Remove the pin to install the steering wheel switch housing as shown in the illustration.



Hide 84329 2.INSTALL TURN SIGNAL SWITCH

Hide 84650 3.INSTALL WINDSHIELD WIPER SWITCH ASSEMBLY

Hide 89235A 4.INSTALL TILT AND TELESCOPIC SWITCH (for Power Tilt and Power Telescopic Steering Column)

Hide 5.INSTALL SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY