The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during hazard warning signal switch assembly removal/installation are shown below.
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
1.REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
55971C
2.REMOVE NO. 1 SIDE DEFROSTER NOZZLE DUCT
55972C
3.REMOVE NO. 2 SIDE DEFROSTER NOZZLE DUCT
55950G
4.REMOVE DEFROSTER NOZZLE ASSEMBLY
83108
5.REMOVE METER MIRROR SUB-ASSEMBLY (w/ Headup Display)
55084E
6.REMOVE NO. 1 HEATER TO REGISTER DUCT SUB-ASSEMBLY
55086
7.REMOVE NO. 3 HEATER TO REGISTER DUCT SUB-ASSEMBLY
55085
8.REMOVE NO. 2 HEATER TO REGISTER DUCT SUB-ASSEMBLY
55660
9.REMOVE NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY
84330
10.REMOVE HAZARD WARNING SIGNAL SWITCH ASSEMBLY
| *a | Protective Tape |
|
Remove in this Direction |
Using a screwdriver with its tip wrapped with protective tape, disengage the 2 claws and remove the hazard warning signal switch assembly as shown in the illustration.