Home › Vehicle Exterior › LIGHTING (EXT) › HEIGHT CONTROL SENSOR › 2017.09–2018.04
RM33C0E _59 Vehicle Exterior _065472 LIGHTING (EXT) _0330508 HEIGHT CONTROL SENSOR A

LIGHTING (EXT)  HEIGHT CONTROL SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during rear height control sensor sub-assembly LH removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Rear height control sensor sub-assembly LH Perform headlight ECU sub-assembly LH initialization Lighting system (EXT) (Click here)

PROCEDURE

Hide 1.REMOVE REAR WHEEL (for LH Side)

Hide 89408C 2.REMOVE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH

NOTICE:

If the rear height control sensor sub-assembly LH has been struck or dropped, replace it with a new one.


a.
E371340

Disconnect the connector.


b.

Remove the 2 bolts.


c.

Disengage the 2 guides to remove the rear height control sensor sub-assembly LH.