The headlight ECU sub-assembly LH stores this DTC if initialization has not been performed after it was replaced.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from |
|---|---|---|---|---|
| B2450 | Height Sensor Initialization Incomplete | Detection condition:
The power switch is on (IG). Malfunction status:
Headlight ECU sub-assembly LH initialization not completed Malfunction duration:
- |
Headlight ECU sub-assembly LH | HL AutoLeveling |
If the headlight ECU sub-assembly LH has been replaced, it is necessary to synchronize the vehicle information and initialize the headlight ECU sub-assembly LH.
Perform initialization of the headlight ECU sub-assembly LH.
| Proceed to |
|---|
| NEXT |
NEXT
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / HL AutoLeveling / Trouble Codes.
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
NEXT
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / HL AutoLeveling / Trouble Codes.
Check for DTCs.
DTC B2450 is not output.
If the headlight ECU sub-assembly LH stores DTC B2450 even though the ECU has been initialized, there may be a malfunction in the headlight ECU sub-assembly LH.
| Proceed to |
|---|
| OK |
| NG |
OK
NG