The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during blower unit removal/installation are shown below.
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
Before removing the blower assembly, set the air conditioning to recirculation mode.
1.REMOVE AIR CONDITIONER UNIT ASSEMBLY
82142
2.REMOVE NO. 2 INSTRUMENT PANEL WIRE
87211A
3.REMOVE NO. 2 AIR DUCT
87130D
4.REMOVE BLOWER ASSEMBLY
for LHD:
Disconnect the connector.
Disengage each guide.
Remove the 2 screws.
Disengage the 2 claws and 2 guides and remove the blower assembly from the air conditioning radiator assembly.
for RHD:
Disconnect the connector.
Disengage each guide.
Remove the 2 screws.
Disengage the 2 claws and 2 guides and remove the blower assembly from the air conditioning radiator assembly.