Home › Vehicle Interior › HEATING / AIR CONDITIONING › ION GENERATOR › 2017.09–2017.12
RM33C0E _58 Vehicle Interior _065464 HEATING / AIR CONDITIONING _0331722 ION GENERATOR A

HEATING / AIR CONDITIONING  ION GENERATOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during ion generator sub-assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function When Necessary Procedures are not Performed Link
Disconnect cable from negative (-) auxiliary battery terminal Perform steering sensor zero point calibration Lane departure alert system (w/ steering control) (Click here)
Pre-collision system
Memorize steering angle neutral point Parking assist monitor system (Click here)

CAUTION:
B401522

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION


PROCEDURE

Hide 1.REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

Hide 55971C 2.REMOVE NO. 1 SIDE DEFROSTER NOZZLE DUCT

Hide 55084E 3.REMOVE NO. 1 HEATER TO REGISTER DUCT SUB-ASSEMBLY

Hide 87201N 4.REMOVE AIR DUCT SUB-ASSEMBLY (for RHD)

a.
E371461C01
0,0 0,0 false
V113147

Remove in this Direction


Remove the screw and air duct sub-assembly as shown in the illustration.


Hide 5.REMOVE ION GENERATOR WITH BRACKET

a.

for LHD:

i.
E375020

Disconnect the connector.


ii.

Remove the 2 screws.


iii.

Disengage the 2 guides to remove the ion generator with bracket.



b.

for RHD:

i.
E371463

Disconnect the connector.


ii.

Remove the 2 screws.


iii.

Disengage the 2 guides to remove the ion generator with bracket.



Hide 87201N 6.REMOVE AIR DUCT SUB-ASSEMBLY (for LHD)

a.
E375021C01
0,0 0,0 false
V113147

Remove in this Direction


Remove the screw and air duct sub-assembly as shown in the illustration.


Hide 88051A 7.REMOVE ION GENERATOR SUB-ASSEMBLY

a.
E375023

Remove the 3 screws and ion generator sub-assembly from the No. 1 ion generator bracket.