73900
1.INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (for LHD)
Check that the power switch is off.
Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
| *a | Airbag Connector |
| *b | Airbag Connector Locking Button |
|
Push in this Direction |
Connect the airbag connector to the lower No. 1 instrument panel airbag assembly.
When connecting any airbag connector, take care not to damage the airbag wire harness.
Push in the airbag connector locking button to install the airbag connector.
Engage the 2 hooks to temporarily install the lower No. 1 instrument panel airbag assembly.
Engage the 2 claws.
Install the lower No. 1 instrument panel airbag assembly with the 4 bolts.
Confirm that the lower No. 1 instrument panel airbag assembly is installed securely without any excessive gaps and is not protruding outward.
73900
2.INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (for RHD)
Check that the power switch is off.
Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
| *a | Airbag Connector |
| *b | Airbag Connector Locking Button |
|
Push in this Direction |
Connect the airbag connector to the lower No. 1 instrument panel airbag assembly.
When connecting any airbag connector, take care not to damage the airbag wire harness.
Push in the airbag connector locking button to install the airbag connector.
Engage the 2 hooks to temporarily install the lower No. 1 instrument panel airbag assembly.
Engage the 2 claws.
Install the lower No. 1 instrument panel airbag assembly with the 4 bolts.
Confirm that the lower No. 1 instrument panel airbag assembly is installed securely without any excessive gaps and is not protruding outward.
55434B
3.INSTALL LOWER CENTER INSTRUMENT PANEL FINISH PANEL
55435B
4.INSTALL NO. 1 METER HOOD CLUSTER
55302D
5.INSTALL NO. 1 INSTRUMENT PANEL SUB-ASSEMBLY
53601
6.CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
55436B
7.INSTALL NO. 2 METER HOOD CLUSTER
55606
8.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for LHD)
55606
9.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for RHD)
55318C
10.INSTALL INSTRUMENT SIDE PANEL
62312B
11.CONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP
62112A
12.INSTALL COWL SIDE TRIM SUB-ASSEMBLY
67914
13.INSTALL FRONT DOOR SCUFF PLATE
14.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
Click hereGeneral>MAINTENANCE>AUXILIARY BATTERY>INSTALLATION
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
64718C
15.INSTALL LUGGAGE TRIM SERVICE HOLE COVER
16. PERFORM DIAGNOSTIC SYSTEM CHECK
17.INSPECT SRS WARNING LIGHT