73990
1.INSTALL LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY
Check that the power switch is off.
Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
| *a | Airbag Connector |
| *b | Airbag Connector Locking Button |
|
Push in this Direction |
Connect the airbag connector to the lower No. 2 instrument panel airbag assembly.
When connecting any airbag connector, take care not to damage the airbag wire harness.
Push in the airbag connector locking button to install the airbag connector.
Engage the 3 claws to temporarily install the lower No. 2 instrument panel airbag assembly.
Install the lower No. 2 instrument panel airbag assembly with the 3 bolts.
Confirm that the lower No. 2 instrument panel airbag assembly is installed securely without any excessive gaps and is not protruding outward.
55476C
2.INSTALL INSTRUMENT PANEL FINISH PLATE GARNISH
55012A
3.INSTALL NO. 2 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY
55435B
4.INSTALL NO. 1 METER HOOD CLUSTER
55607
5.INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
55317A
6.INSTALL INSTRUMENT SIDE PANEL RH
62311B
7.CONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP RH
62111A
8.INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH
Use the same procedure as for the LH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>INSTALLATION
67913
9.INSTALL FRONT DOOR SCUFF PLATE RH
Use the same procedure as for the LH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>INSTALLATION
10.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
Click hereGeneral>MAINTENANCE>AUXILIARY BATTERY>INSTALLATION
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
64718C
11.INSTALL LUGGAGE TRIM SERVICE HOLE COVER
12. PERFORM DIAGNOSTIC SYSTEM CHECK
13.INSPECT SRS WARNING LIGHT