89952
1.INSTALL OCCUPANT DETECTION ECU
Engage the claw to install the occupant detection ECU.
If the occupant detection ECU has been dropped, or there are any cracks, dents or other defects in the case or connector, replace the occupant detection ECU with a new one.
Connect the 2 connectors.
When installing the occupant detection ECU, be careful that the SRS wiring does not interfere with or is not pinched between other parts.
2.INSTALL FRONT SEAT ASSEMBLY RH
3. PERFORM DIAGNOSTIC SYSTEM CHECK
4. PERFORM ZERO POINT CALIBRATION AND SENSITIVITY CHECK