Home › Drivetrain › AXLE AND DIFFERENTIAL › REAR AXLE HUB
RM33C0E _52 Drivetrain _065436 AXLE AND DIFFERENTIAL _0331918 REAR AXLE HUB A

AXLE AND DIFFERENTIAL  REAR AXLE HUB  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 42450B 1.INSTALL REAR AXLE HUB AND BEARING ASSEMBLY

a.

Install the rear axle hub and bearing assembly and rear disc brake dust cover sub-assembly to the rear axle carrier sub-assembly with the 4 bolts.

Torque:
90 N*m (918 kgf*cm, 66 ft.*lbf)


Hide 2.INSPECT REAR AXLE HUB BEARING LOOSENESS

Hide 42431 4.INSTALL REAR DISC

Hide 5.INSTALL REAR DISC BRAKE CALIPER ASSEMBLY

Hide 890C0A 6.CONNECT NO. 2 PARKING BRAKE WIRE ASSEMBLY

a.

Connect the No. 2 parking brake wire assembly connector to the parking brake actuator assembly.


b.

Connect the No. 2 parking brake wire assembly connector to the rear axle hub and bearing assembly.


Hide 7.INSTALL REAR WHEEL

Hide 8.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

a.

Connect the reservoir level switch connector.


b.

Connect the cable to the negative (-) auxiliary battery terminal.

Click hereGeneral>MAINTENANCE>AUXILIARY BATTERY>INSTALLATION


c.

Turn the power switch on (READY).


d.

Depress the brake pedal and release it.