Signals are input into the position control ECU assembly. The built-in ECU manages the signals received from the power seat switch and operates each motor. If the position control ECU assembly receives more than 2 motor operation signals for the same motor, the motor will be stopped. Manual operation resumes when the position control ECU assembly receives only 1 signal.
Inspect the fuses for circuits related to this system before performing the following procedure.
Check that each function of the power seat operates normally by using the front power seat switch (driver seat).
Click hereVehicle Interior>SEAT>FRONT POWER SEAT CONTROL SYSTEM (w/ Memory)>OPERATION CHECK
| Result | Proceed to |
|---|---|
| All power seat functions do not operate | A |
| One or more power seat functions do not operate | B |
A
B
Remove the front power seat switch (driver seat).
Click hereVehicle Interior>SEAT>POWER SEAT SWITCH(for Front Side)>REMOVAL
Inspect the front power seat switch (driver seat).
Click hereVehicle Interior>SEAT>POWER SEAT SWITCH(for Front Side)>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the a29 and a31 position control ECU assembly (driver seat) connectors.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| a29-3 (+B) - Body ground | Power switch off | 11 to 14 V |
| a31-15 (SYSB) - Body ground | Power switch off | 11 to 14 V |
| a31-1 (IG) - Body ground | Power switch on (IG) | 11 to 14 V |
| a31-1 (IG) - Body ground | Power switch off | Below 1 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| a31-12 (SENG) - a35-11 (E) | Always | Below 1 Ω |
| a31-12 (SENG) or a35-11 (E) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| a29-2 (GND) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG