Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Audio and Visual System.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM>PRECAUTION
When replacing the radio and display receiver assembly, always replace it with a new one. If a radio and display receiver assembly which was installed to another vehicle is used, the following may occur:
A communication malfunction DTC may be stored.
The radio and display receiver assembly may not operate normally.
Press the disc eject switch of the radio and display receiver assembly for 5 seconds or more and check that the disc is ejected.
Disc is ejected.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the disc with a new or known good one and check that the malfunction disappears.
Disc is ejected.
| Proceed to |
|---|
| OK |
| NG |
OK
NG