The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during rear stereo component speaker assembly removal/installation are shown below.
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
1. PRECAUTION
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
64718C
2.REMOVE LUGGAGE TRIM SERVICE HOLE COVER
3.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
Click hereGeneral>MAINTENANCE>AUXILIARY BATTERY>REMOVAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
If an airbag deploys for any reason, it may cause a serious injury.
73350C
4.DISCONNECT REAR CENTER SEAT OUTER BELT ASSEMBLY
5.REMOVE REAR SEAT CUSHION ASSEMBLY
72693
6.REMOVE REAR SEAT CUSHION LOCK HOOK
62332A
7.DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP LH
8.REMOVE REAR SIDE SEATBACK ASSEMBLY LH
62331A
9.DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP RH
Use the same procedure as for the LH side.
10.REMOVE REAR SIDE SEATBACK ASSEMBLY RH
Use the same procedure as for the LH side.
62472A
11.REMOVE INNER ROOF SIDE GARNISH LH
62471A
12.REMOVE INNER ROOF SIDE GARNISH RH
Use the same procedure as for the LH side.
73370E
13.DISCONNECT REAR SEAT OUTER BELT ASSEMBLY LH
73360D
14.DISCONNECT REAR SEAT OUTER BELT ASSEMBLY RH
Use the same procedure as for the LH side.
81006
15.REMOVE CENTER STOP LIGHT SET
73373F
16.REMOVE REAR SEAT SHOULDER BELT HOLE COVER
64330
17.REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY
86160N
18.REMOVE REAR STEREO COMPONENT SPEAKER ASSEMBLY
Do not touch the speaker cone.
Remove the 4 bolts.
Disconnect the connector.
Disengage the guide to remove the rear stereo component speaker assembly.