Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM
RM33C0E _56 Audio / Visual / Telematics _065452 PARK ASSIST / MONITORING _0333742 BLIND SPOT MONITOR SYSTEM C

PARK ASSIST / MONITORING  BLIND SPOT MONITOR SYSTEM  C1A46  Yaw Rate Sensor  


DESCRIPTION

The blind spot monitor sensor receives yaw rate signals from the airbag sensor assembly (yaw rate and acceleration sensor) via CAN communication.

Blind Spot Monitor Master
DTC No. Detection Item DTC Detection Condition Trouble Area
C1A46 Yaw Rate Sensor A fail flag is transmitted from the airbag sensor assembly
·

Electronically controlled brake system

·

Blind spot monitor sensor RH



Blind Spot Monitor Slave
DTC No. Detection Item DTC Detection Condition Trouble Area
C1A46 Yaw Rate Sensor A fail flag is transmitted from the airbag sensor assembly
·

Electronically controlled brake system

·

Blind spot monitor sensor LH



CAUTION / NOTICE / HINT

NOTICE:

When checking for DTCs, make sure that the blind spot monitor system is turned on.


PROCEDURE

1.CHECK OTHER DTC OUTPUT (ELECTRONICALLY CONTROLLED BRAKE SYSTEM)
a.

Check for electrical controlled brake system DTCs.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>DTC CHECK / CLEAR

OK:

Electronically controlled brake system DTCs are not output.



Result:
Proceed to
OK
NG



OK

2.RECHECK DTC

NG

2.RECHECK DTC
a.

Turn the power switch off.


b.

Turn the power switch on (IG).


c.

Recheck for DTCs and check if the same DTC is output again.

Body Electrical > Blind Spot Monitor Master > Trouble Codes
50001 313
Body Electrical > Blind Spot Monitor Slave > Trouble Codes
50001 314

Result:
Result Proceed to
No DTCs are output. A
DTC C1A46 is output ("Blind Spot Monitor Master"). B
DTC C1A46 is output ("Blind Spot Monitor Slave"). C



A

B

C