Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION ANTENNA › 2017.09–2019.02
RM33C0E _56 Audio / Visual / Telematics _065451 NAVIGATION / MULTI INFO DISPLAY _0333832 NAVIGATION ANTENNA A

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION ANTENNA  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during navigation antenna assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function When Necessary Procedures are not Performed Link
Disconnect cable from negative auxiliary battery terminal Perform steering sensor zero point calibration Lane departure alert system (w/ steering control) (Click here)
Pre-collision system
Memorize steering angle neutral point Parking assist monitor system (Click here)

CAUTION:
B401522

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION


PROCEDURE

Hide 1.REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

Hide 55086 2.REMOVE NO. 3 HEATER TO REGISTER DUCT SUB-ASSEMBLY

Hide 3.REMOVE NAVIGATION ANTENNA ASSEMBLY WITH BRACKET

a.
E365410

Disconnect the connector.


b.

Disengage the 2 claws.


c.
E365411

Remove the 2 screws and navigation antenna assembly with bracket.


Hide 86860 4.REMOVE NAVIGATION ANTENNA ASSEMBLY

a.
E371153C02
0,0 0,0 false
V113147

Remove in this Direction


Disengage the 2 claws and 6 guides to remove the navigation antenna assembly as shown in the illustration.


Hide 86862 5.REMOVE NAVIGATION ANTENNA BRACKET