The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during steering column assembly removal/installation are shown below.
1. PRECAUTION
2. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD
45130
3.REMOVE HORN BUTTON ASSEMBLY
4.REMOVE STEERING WHEEL ASSEMBLY
45024
5.REMOVE LOWER STEERING COLUMN COVER SUB-ASSEMBLY
Removing the lower steering column cover sub-assembly in the incorrect order will cause the parts to break.
Release the tilt and telescopic lever and fully extend and lower the steering column assembly.
Lock the tilt and telescopic lever.
Remove the 3 screws.
|
Push Area |
|
Push in this Direction |
While pressing the push area shown in the illustration to disengage the 2 claws, slightly lower the lower steering column cover sub-assembly.
45286B
6.REMOVE UPPER STEERING COLUMN COVER
|
Separate in this direction |
Disengage the claw and separate the upper steering column cover.
Disengage the 2 claws and 4 clips to remove the upper steering column cover.
7.REMOVE TURN SIGNAL SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY
Do not remove/install the spiral cable with sensor sub-assembly with the battery connected and the power switch on (IG).
Do not rotate the spiral cable with sensor sub-assembly without the steering wheel assembly installed, with the battery connected and the power switch on (IG).
Ensure that the steering wheel assembly is installed and aligned straight when inspecting the steering sensor.
Disconnect each connector from the turn signal switch assembly with spiral cable sub-assembly.
| *a | Clamp |
Using pliers, expand the clamp.
While holding the clamp expanded, raise the claw using a screwdriver to disengage it, and then remove the turn signal switch assembly with spiral cable sub-assembly from the steering column assembly.
73900
8.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
87211
9.REMOVE NO. 1 AIR DUCT (for LHD)
| *a | View A |
|
Front |
Remove the 2 bolts.
Disengage the 3 claws to remove the No. 1 air duct.
Be careful not to deform or damage the lower heater case of the air conditioner unit assembly when removing the No. 1 air duct.
87211
10.REMOVE NO. 1 AIR DUCT (for RHD)
| *a | View A |
|
Front |
Remove the 2 bolts.
Disengage the 3 claws to remove the No. 1 air duct.
Be careful not to deform or damage the lower heater case of the air conditioner unit assembly when removing the No. 1 air duct.
11.REMOVE FRONT WHEEL LH (for LHD)
12.REMOVE FRONT WHEEL RH (for RHD)
45220
13.SEPARATE STEERING INTERMEDIATE SHAFT ASSEMBLY
45253
14.REMOVE STEERING COLUMN HOLE COVER
Turn back the floor carpet.
Remove the clip.
Disengage the 2 clips to remove the steering column hole cover.
45220
15.REMOVE STEERING INTERMEDIATE SHAFT ASSEMBLY
Using a screwdriver, loosen the clamp as shown in the illustration.
| *a | Matchmark |
Remove the bolt and slide the steering intermediate shaft assembly.
Do not remove the steering intermediate shaft assembly from the steering column assembly.
Put matchmarks on the steering intermediate shaft assembly and steering column assembly.
Remove the steering intermediate shaft assembly from the steering column assembly.
45250
16.REMOVE STEERING COLUMN ASSEMBLY
Disconnect each connector and disengage each wire harness clamp from the steering column assembly.
Remove the bolt, 2 nuts and steering column assembly.