The main body ECU (multiplex network body ECU) and windshield wiper motor assembly communicate via LIN communication. The main body ECU (multiplex network body ECU) stores this DTC if communication becomes abnormal.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Memory | DTC Output from |
|---|---|---|---|---|---|
| B1373 | Lost Communication with Wiper System LIN BUS | Detection condition:
Auxiliary battery voltage is 9.5 V or more Malfunction Status:
A malfunction in the communication or LIN communication line between the main body ECU (multiplex network body ECU) and components of the wiper system occurs Malfunction Time:
7 seconds or more 3 times consecutively |
·
Windshield wiper motor assembly ·
Main body ECU (multiplex network body ECU) ·
Harness or connector ·
Rain sensor |
○ | Main Body |
Before replacing the main body ECU (multiplex network body ECU), refer to Service Bulletin.
Choose the model to be inspected.
| Result | Proceed to |
|---|---|
| w/o Auto Wiper System | A |
| w/ Auto Wiper System | B |
A
B
Disconnect the K51 main body ECU (multiplex network body ECU) connector.
Disconnect the A31 windshield wiper motor assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| K51-3 (LIN3) or A31-3 (LIN) - Body ground | Always | 10 kΩ Higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Component without harness connected
(Main Body ECU (Multiplex Network Body ECU) |
Check for voltage and pulses according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| K51-3 (LIN3) - Body ground | Power switch off | Below 1 V |
| Power switch ON | Pulse generation |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the V4*1 or V5*2 rain sensor connector.
*1: for LHD
*2: for RHD
Clear the DTCs.
Turn the power switch on (IG) and wait for at least 10 seconds.
Check for DTCs.
| Result | Proceed to |
|---|---|
| Only DTC B1279 is output | A |
| DTC B1373 is output | B |
A
B
Disconnect the A31 windshield wiper motor assembly connector.
Clear the DTCs.
Turn the power switch on (IG) and wait for at least 10 seconds.
Check for DTCs.
| Result | Proceed to |
|---|---|
| Only DTC B1245 is output | A |
| DTC B1373 is output | B |
A
B
Disconnect the K51 main body ECU (multiplex network body ECU) connector.
Clear the DTCs.
Turn the power switch on (IG) and wait for at least 10 seconds.
Check for DTCs.
| Result | Proceed to |
|---|---|
| DTC B1373 is not output | A |
| DTC B1373 is output | B |
A
B