Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM › 2017.12–2021.02
RM33C0E _58 Vehicle Interior _065464 HEATING / AIR CONDITIONING _0329891 AIR CONDITIONING SYSTEM J

HEATING / AIR CONDITIONING  AIR CONDITIONING SYSTEM  Operation not Accepted Even If Air Conditioning Switch is Operated  


DESCRIPTION

If the air conditioning system cannot be operated using the air conditioning control panel (radio and display receiver assembly)*1 or air conditioning control assembly*2, the following factors may be the cause.

Symptom Factor
Air conditioning system cannot be operated using air conditioning control panel (radio and display receiver assembly)*1 or air conditioning control assembly*2

(With the exception of the switch indicators, no inputs are reflected when other switches operated)


·

CAN communication malfunction between air conditioning amplifier assembly and air conditioning control panel (radio and display receiver assembly)*1

·

LIN communication malfunction between air conditioning amplifier assembly and air conditioning control assembly*2

·

Short to +B or ground in air conditioning amplifier assembly circuit

·

Air conditioning amplifier assembly malfunction

·

Air conditioning control panel (radio and display receiver assembly) malfunction*1

·

Air conditioning control assembly malfunction*2

·

Harness or connector



*1: for 8 Inch Display

*2: except 8 Inch Display


WIRING DIAGRAM

for 8 Inch Display


E374215E01
0.823,2.948 3.365,3.333 2.542,0.385 10 false Air Conditioning Control Panel (Radio and Display Receiver Assembly) 4.844,2.917 7.146,3.135 2.302,0.219 10 false Air Conditioning Amplifier Assembly 4.719,3.448 6.458,3.656 1.74,0.208 10 false : CAN Communication Line 0.896,1.406 1.208,1.604 0.313,0.198 10 false h1 0.906,0.979 1.219,1.177 0.313,0.198 10 false h1 0.896,2.198 1.208,2.396 0.313,0.198 10 false K1 0.885,2.604 1.198,2.802 0.313,0.198 10 false K1 1.208,0.99 1.615,1.198 0.406,0.208 10 false UIND 1.219,2.615 1.625,2.823 0.406,0.208 10 false UIND 1.208,1.417 1.698,1.635 0.49,0.219 10 false UPSW 1.219,2.188 1.708,2.406 0.49,0.219 10 false UPSW 0.938,2.417 1.177,2.583 0.24,0.167 10 false 8 0.938,1.979 1.177,2.146 0.24,0.167 10 false 9 0.896,1.208 1.188,1.427 0.292,0.219 10 false 14 0.906,0.781 1.198,1 0.292,0.219 10 false 13 2.104,1.698 2.51,1.906 0.406,0.208 10 false GND 2.615,1.5 2.854,1.667 0.24,0.167 10 false 6 2.167,1.24 2.573,1.448 0.406,0.208 10 false IG+ 2.625,1.031 2.865,1.198 0.24,0.167 10 false 2 2.219,0.292 2.625,0.5 0.406,0.208 10 false +B 2.625,0.094 2.865,0.26 0.24,0.167 10 false 3 3.042,0.438 4.042,0.667 1,0.229 10 false ECU-B NO. 2 3.125,0.906 3.865,1.104 0.74,0.198 10 false ECU-ACC 4.427,0.302 5.938,0.542 1.51,0.24 10 false from Auxiliary Battery 4.438,0.771 5.708,1 1.271,0.229 10 false from ACC Relay 2.135,0.781 2.542,0.99 0.406,0.208 10 false ACC 2.583,0.573 2.823,0.74 0.24,0.167 10 false 10 2.99,1.365 4.063,1.573 1.073,0.208 10 false ECU-IG1 NO. 4 4.427,1.229 5.917,1.458 1.49,0.229 10 false from IG1-NO. 1 Relay 2.583,1.698 2.896,1.896 0.313,0.198 10 false h1 2.594,1.229 2.906,1.427 0.313,0.198 10 false h1 2.594,0.771 2.906,0.969 0.313,0.198 10 false h1 2.594,0.302 2.906,0.5 0.313,0.198 10 false h1


except 8 Inch Display


E375276E01
2.052,0.604 3.469,0.833 1.417,0.229 10 false from Auxiliary Battery 2.052,1.115 3.469,1.344 1.417,0.229 10 false from IG1-NO. 1 Relay 3.979,0.75 4.885,0.958 0.906,0.208 10 false ECU-B NO. 2 3.927,1.271 4.99,1.479 1.063,0.208 10 false ECU-IG1 NO. 4 5.26,0.625 5.51,0.792 0.25,0.167 10 false B 5.26,1.667 5.667,1.865 0.406,0.198 10 false LIN1 1.646,1.667 2.052,1.865 0.406,0.198 10 false LIN1 5.25,1.125 5.656,1.323 0.406,0.198 10 false IG+ 5.26,2.385 5.667,2.583 0.406,0.198 10 false GND 5.063,0.49 5.313,0.656 0.25,0.167 10 false 1 5.01,1.5 5.271,1.677 0.26,0.177 10 false 14 5.063,1.01 5.323,1.188 0.26,0.177 10 false 2 5.083,2.26 5.344,2.438 0.26,0.177 10 false 4 2.021,1.51 2.281,1.688 0.26,0.177 10 false 9 0.583,2.906 2.781,3.115 2.198,0.208 10 false Air Conditioning Control Assembly 0.583,2.729 0.99,2.927 0.406,0.198 10 false K26 4.927,2.771 5.333,2.969 0.406,0.198 10 false K54 4.917,2.948 7.115,3.156 2.198,0.208 10 false Air Conditioning Amplifier Assembly 0.948,3.396 2.771,3.615 1.823,0.219 10 false : LIN Communication Line


CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following procedure.


PROCEDURE

1.CONFIRM MODEL
Result:
Result Proceed to
for 8 Inch Display A
except 8 Inch Display B



A

2.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING CONTROL PANEL (RADIO AND DISPLAY RECEIVER ASSEMBLY) - POWER SOURCE AND BODY GROUND)

B

6.CHECK FOR DTC
2.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING CONTROL PANEL (RADIO AND DISPLAY RECEIVER ASSEMBLY) - POWER SOURCE AND BODY GROUND)
a.

Disconnect the h1 air conditioning control panel (radio and display receiver assembly) connector.


b.

Measure the voltage and resistance according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
h1-3 (+B) - Body ground Power switch off 11 to 14 V
h1-10 (ACC) - Body ground Power switch on (ACC) 11 to 14 V
h1-2 (IG+) - Body ground Power switch on (IG) 11 to 14 V


Standard Resistance:
Tester Connection Condition Specified Condition
h1-6 (GND) - Body ground Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

3.CHECK FOR DTC (AUDIO AND VISUAL SYSTEM)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

3.CHECK FOR DTC (AUDIO AND VISUAL SYSTEM)
a.

Check for DTCs.

Body Electrical > Navigation System > Trouble Codes
50001 212

Result:
Result Proceed to
B15F9 is not output A
B15F9 is output B



A

4.CHECK FOR DTC (CAN COMMUNICATION SYSTEM)

B

REPLACE AIR CONDITIONING CONTROL PANEL (RADIO AND DISPLAY RECEIVER ASSEMBLY)

4.CHECK FOR DTC (CAN COMMUNICATION SYSTEM)
a.

Using the GTS, check for CAN communication system DTCs.

Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>DIAGNOSTIC TROUBLE CODE CHART


Result:
Result Proceed to
CAN communication system DTCs are not output A
CAN communication system DTCs are output B



A

5.PERFORM ACTIVE TEST USING GTS

B

5.PERFORM ACTIVE TEST USING GTS
a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Air Conditioner / Active Test.


e.

Perform the Active Test according to the display on the GTS.

Body Electrical > Air Conditioner > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Blower Motor Blower motor with fan sub-assembly Min.: 0
Max.: 31
-
Body Electrical > Air Conditioner > Active Test
Tester Display
Blower Motor
50004 121 2
OK:

Blower motor with fan sub-assembly operates normally.



Result:
Proceed to
OK
NG



OK

REPLACE AIR CONDITIONING CONTROL PANEL (RADIO AND DISPLAY RECEIVER ASSEMBLY)

NG

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY

6.CHECK FOR DTC
a.

Check for DTCs.

Body Electrical > Air Conditioner > Trouble Codes
50001 121

Result:
Result Proceed to
B14B2 is not output A
B14B2 is output B



A

7.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - POWER SOURCE AND BODY GROUND)

B

7.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - POWER SOURCE AND BODY GROUND)
E328994C12
1.531,0.448 1.917,0.698 0.385,0.25 2.573,1.958 2.75,1.229 2.75,1.229 2.917,1.229 true 0.802,1.979 0.531,1.552 0.531,1.552 0.323,1.552 true 1.021,1.958 0.667,1.302 0.667,1.302 0.458,1.302 true 0.146,0.125 0.458,0.323 0.313,0.198 10 false *a 1.604,0.479 1.927,0.656 0.323,0.177 10 false K54 2.969,1.135 3.344,1.333 0.375,0.198 10 false GND 0.208,1.208 0.521,1.385 0.313,0.177 10 false IG+ 0.198,1.458 0.354,1.625 0.156,0.167 10 false B
*a Front view of wire harness connector
(to Air Conditioning Amplifier Assembly)


a.

Disconnect the K54 air conditioning amplifier assembly connector.


b.

Measure the voltage and resistance according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
K54-1 (B) - Body ground Power switch off 11 to 14 V
K54-2 (IG+) - Body ground Power switch on (IG) 11 to 14 V
Power switch off Below 1 V


Standard Resistance:
Tester Connection Condition Specified Condition
K54-4 (GND) - Body ground Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR