The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during lumbar support adjuster assembly RH removal/installation are shown below.
Be sure to read Precaution thoroughly before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
Wear protective gloves. Sharp areas on the parts may injure your hands.
1.REMOVE FRONT SEAT ASSEMBLY RH
71073S
2.DISCONNECT SEPARATE TYPE FRONT SEATBACK COVER
72494
3.REMOVE VERTICAL ADJUSTING HANDLE RH
72551B
4.REMOVE RECLINING HINGE COVER RH
72525A
5.REMOVE RECLINING ADJUSTER RELEASE HANDLE RH
71848A
6.REMOVE SEAT ADJUSTER COVER CAP RH
71811D
7.REMOVE FRONT SEAT CUSHION SHIELD RH
71861
8.REMOVE FRONT SEAT INNER CUSHION SHIELD RH
9.REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY
71931
10.REMOVE FRONT SEAT HEADREST SUPPORT
11.REMOVE SEPARATE TYPE FRONT SEATBACK COVER WITH PAD
72750D
12.REMOVE LUMBAR SUPPORT ADJUSTER ASSEMBLY RH
Disconnect the connector.
Disengage the clamp.
Disengage the 2 claws to remove the 2 front seatback edge protectors from the front seatback frame sub-assembly.
|
Remove in this Direction |
Remove the lumbar support adjuster assembly RH from the front seatback frame sub-assembly as shown in the illustration.
71587
13.REMOVE FRONT SEATBACK EDGE PROTECTOR