The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front crankshaft oil seal removal/installation are shown below.
Necessary Procedure After Parts Removed/Installed/Replaced
| Replaced Part or Performed Procedure
|
Necessary Procedure
|
Effect/Inoperative Function when Necessary Procedure not Performed
|
Link
|
| Auxiliary battery terminal is disconnected/reconnected
|
Perform steering sensor zero point calibration
|
Lane departure alert system (w/ Steering Control)
|
( )
|
| Pre-collision system
|
| Memorize steering angle neutral point
|
Parking Assist Monitor System
|
( )
|
| Replacement of ECM
|
Vehicle Identification Number (VIN) or frame number registration
|
MIL illuminates
|
( )(w/ Canister Pump Module)
( )(w/o Canister Pump Module)
|
·
Gas leak from exhaust system is repaired
·
Replacement of air fuel ratio sensor
|
Inspection After Repair
|
·
Engine start function, etc.
|
( )(w/ Canister Pump Module)
( )(w/o Canister Pump Module)
|
| Replacement of inverter with converter assembly
|
Resolver learning
|
·
Slight vibration at a vehicle speed of 5 km/h (3 mph) or less
·
Shock or vibration during acceleration
|
( )
|
| Replacement of hybrid vehicle transaxle assembly
|
|
Suspension, tires, etc.
(The vehicle height changes because of suspension or tire replacement)
|
Rear television camera assembly optical axis (Back camera position setting)
|
Parking assist monitor system
|
( )for Initialization
( )for Calibration
|
| Replacement of headlight ECU sub-assembly LH
|
·
Synchronize the vehicle information
·
Perform headlight ECU sub-assembly LH initialization
|
Lighting System (EXT) (w/ Automatic Headlight Beam Level Control System)
|
( )
|
Suspension, tires, etc.
(The vehicle height changes because of suspension or tire replacement)
|
Perform headlight ECU sub-assembly LH initialization
|
| Front wheel alignment adjustment
|
1.
Clear zero point calibration data.
2.
Perform yaw rate and acceleration sensor zero point calibration.
|
·
ABS warning light illuminates
·
Brake warning light / yellow (minor malfunction) illuminates
·
Slip indicator light illuminates
·
VSC disabled or malfunctions
|
( )
|
- NOTICE:
-
This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
-
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION