Home › Vehicle Exterior › VEHICLE PROXIMITY NOTIFICATION SYSTEM › VEHICLE PROXIMITY NOTIFICATION SYSTEM (w/ Vehicle Approaching Speaker Switch) › 2018.08–2019.10
RM33C0E _59 Vehicle Exterior _074891 VEHICLE PROXIMITY NOTIFICATION SYSTEM _0363660 VEHICLE PROXIMITY NOTIFICATION SYSTEM J

VEHICLE PROXIMITY NOTIFICATION SYSTEM  VEHICLE PROXIMITY NOTIFICATION SYSTEM  Sound does not Turn ON or OFF when the Vehicle Approaching Speaker Switch is Pressed  


DESCRIPTION

When the vehicle approaching speaker switch is pushed when the vehicle approaching speaker system is on, the vehicle approaching speaker controller receives a signal to temporarily suspend output of the warning sound from the vehicle approaching speaker assembly.

WIRING DIAGRAM

E369728E05
1.292,2.354 1.75,2.552 0.458,0.198 10 false K155 1.302,2.51 3.646,2.927 2.344,0.417 10 false Vehicle Approaching Speaker Switch 2.865,1.385 3.094,1.635 0.229,0.25 10 false IG 2.74,1.906 3.146,2.104 0.406,0.198 10 false ECU 3.125,1.375 3.313,1.573 0.188,0.198 10 false 5 3.125,1.906 3.313,2.104 0.188,0.198 10 false 2 5.052,1.896 5.24,2.094 0.188,0.198 10 false 5 5.25,1.896 5.51,2.083 0.26,0.188 10 false SW 4.5,3.052 7.073,3.323 2.573,0.271 10 false Vehicle Approaching Speaker Controller 4.5,2.896 4.958,3.094 0.458,0.198 10 false K156 2.469,0.74 3.583,1.031 1.115,0.292 10 false ECU-IG1 NO. 3 0.198,0.552 1.719,0.854 1.521,0.302 10 false from IG1-NO. 1 Relay

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses of circuits related to this system before performing the following procedure.


PROCEDURE

1.READ VALUE USING GTS
a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Vehicle Proximity Notification System / Data List.


e.

Read the Data List according to the display on the GTS.

Body Electrical > Vehicle Proximity Notification System > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Operation Cancel SW Vehicle approaching speaker switch signal OFF or ON OFF: Vehicle approaching speaker switch is not pressed
ON: Vehicle approaching speaker switch is pressed
-
Body Electrical > Vehicle Proximity Notification System > Data List
Tester Display
Operation Cancel SW
50003 359 9

Result:
Result Proceed to
The GTS display changes according to the operation of the vehicle approaching speaker switch but the warning sound does not stop A
The GTS display changes according to the operation of the vehicle approaching speaker switch but the warning sound does not start B
The GTS display does not change according to the operation of the vehicle approaching speaker switch C



A

B

C

2.INSPECT VEHICLE APPROACHING SPEAKER SWITCH
2.INSPECT VEHICLE APPROACHING SPEAKER SWITCH


Result:
Proceed to
OK
NG



OK

3.CHECK HARNESS AND CONNECTOR (IG POWER SOURCE - VEHICLE APPROACHING SPEAKER SWITCH)

NG

3.CHECK HARNESS AND CONNECTOR (IG POWER SOURCE - VEHICLE APPROACHING SPEAKER SWITCH)
a.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
K155-5 (IG) - Body ground Power switch on (IG) 11 to 14 V
Power switch off Below 1 V



Result:
Proceed to
OK
NG



OK

4.CHECK HARNESS AND CONNECTOR (VEHICLE APPROACHING SPEAKER SWITCH - VEHICLE APPROACHING SPEAKER CONTROLLER)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

4.CHECK HARNESS AND CONNECTOR (VEHICLE APPROACHING SPEAKER SWITCH - VEHICLE APPROACHING SPEAKER CONTROLLER)
a.

Disconnect the K156 vehicle approaching speaker controller connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
K155-2 (ECU) - K156-5 (SW) Always Below 1 Ω
K155-2 (ECU) or K156-5 (SW) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR