Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM › 2018.08–2019.02
RM33C0E _58 Vehicle Interior _065464 HEATING / AIR CONDITIONING _0329891 AIR CONDITIONING SYSTEM U

HEATING / AIR CONDITIONING  AIR CONDITIONING SYSTEM  TERMINALS OF ECU  


CHECK AIR CONDITIONING AMPLIFIER ASSEMBLY


E328992C41
2.99,1.969 3.354,2.208 0.365,0.24 4.365,1.969 4.729,2.208 0.365,0.24 5.625,1.969 5.99,2.208 0.365,0.24 3.906,0.125 4.271,0.365 0.365,0.24 5.094,0.125 5.458,0.365 0.365,0.24 2.542,0.125 2.906,0.365 0.365,0.24 1.594,1.979 1.958,2.219 0.365,0.24 3.063,2.01 3.521,2.208 0.458,0.198 10 false K55 4.438,2.01 4.896,2.208 0.458,0.198 10 false K54 5.698,2.01 6.156,2.208 0.458,0.198 10 false z11 2.604,0.177 3.063,0.375 0.458,0.198 10 false K55 3.979,0.167 4.438,0.365 0.458,0.198 10 false K54 5.167,0.167 5.625,0.365 0.458,0.198 10 false z11 0.104,0.094 0.563,0.292 0.458,0.198 12 false *A 0.115,2.01 0.573,2.208 0.458,0.198 12 false *B 1.656,2.021 2.115,2.219 0.458,0.198 10 false K56
*A w/o Seat Heater *B w/ Seat Heater


HINT:

Check from the rear of the connector while it is connected to the air conditioning amplifier assembly.


Terminal No.
(Symbol)
Wiring Color Terminal Description Condition Specified Condition
K54-1 (B) - K54-4 (GND) LA-B - W-B Power source (Back-up) Power switch off 11 to 14 V
K54-2 (IG+) - K54-4 (GND) LA-GR - W-B Power source (IG) Power switch on (IG) 11 to 14 V
Power switch off Below 1 V
K54-4 (GND) - Body ground W-B - Body ground Ground for main power supply Always Below 1 V
K54-6 (BLW) - K54-4 (GND) LG - W-B Blower motor speed control signal
·

Power switch on (IG)

·

Blower switch: LO


Pulse generation
(See waveform 1)
K54-7 (NANO) - K54-4 (GND)* LG - W-B Ion generator sub-assembly operation signal
·

Power switch on (IG)

·

Blower switch: On


Below 1 V
·

Power switch on (IG)

·

Blower switch: Off


4.75 to 5.25 V
K54-11 (CANH) - K54-12 (CANL) SB - W CAN communication system CAN communication is performed Pulse generation
K54-14 (LIN1) - K54-4 (GND) BE - W-B LIN communication signal Power switch on (IG) Pulse generation
(See waveform 2)
K54-26 (NAIN) - K54-4 (GND)* BE - W-B Ion generator sub-assembly operation condition signal
·

Power switch on (IG)

·

Blower switch: On


Below 2.2 V
·

Power switch on (IG)

·

Blower switch: Off


4.75 to 5.25 V
K55-1 (SG-1) - Body ground LG - Body ground Ground for cooler (room temp. sensor) thermistor Always Below 1 V
K55-2 (SG-2) - Body ground W - Body ground Ground for thermistor assembly Always Below 1 V
K55-3 (SG-4) - Body ground L - Body ground Ground for air conditioner pressure sensor Always Below 1 V
K55-6 (S5-3) - K55-3 (SG-4) GR - L Power supply for air conditioner pressure sensor Power switch on (IG) 4.75 to 5.25 V
Power switch off Below 1 V
K55-13 (TAM) - K55-2 (SG-2) R - W Thermistor assembly signal
·

Power switch on (IG)

·

Ambient temperature: 25°C (77°F)


1.05 to 1.45 V
·

Power switch on (IG)

·

Ambient temperature: 40°C (104°F)


0.64 to 0.87 V
K55-14 (TR) - K55-1 (SG-1) GR - LG Cooler (room temp. sensor) thermistor signal
·

Power switch on (IG)

·

Cabin temperature: 25°C (77°F)


1.05 to 1.45 V
·

Power switch on (IG)

·

Cabin temperature: 40°C (104°F)


0.64 to 0.87 V
K55-20 (ECOS) - K54-4 (GND) W - W-B ECO switch assembly (electric parking brake switch assembly) signal
·

Power switch on (IG)

·

ECO switch assembly (electric parking brake switch assembly): off


11 to 14 V
·

Power switch on (IG)

·

ECO switch assembly (electric parking brake switch assembly): On


Below 1 V
K55-24 (PRE) - K55-3 (SG-4) W - L Air conditioner pressure sensor signal
·

Power switch on (READY)

·

Air conditioning system operating

·

Refrigerant pressure: Abnormal pressure (more than 3.025 MPaG (30.8 kgf/cm2, 439 psi))


4.61 V or higher
·

Power switch on (READY)

·

Air conditioning system operating

·

Refrigerant pressure: Abnormal pressure (less than 0.176 MPaG (1.8 kgf/cm2, 26 psi))


Below 0.74 V
·

Power switch on (READY)

·

Air conditioning system operating

·

Refrigerant pressure: Normal pressure (less than 3.025 MPaG (30.8 kgf/cm2, 439 psi) and more than 0.176 MPaG (1.8 kgf/cm2, 26 psi))


0.74 to 4.61 V
z11-2 (BUS G) - Body ground - Ground for BUS IC Always Below 1 V
z11-3 (BUS) - z11-2 (BUS G) - BUS IC control signal Power switch on (IG) Pulse generation
(See waveform 3)
z11-4 (B BUS) - z11-2 (BUS G) - Power supply for BUS IC Power switch off 11 to 14 V
z11-5 (SG) - Body ground GR - Body ground Ground for No. 1 cooler thermistor Always Below 1 V
z11-6 (TE) - z11-5 (SG) GR - GR No. 1 cooler thermistor signal
·

Power switch on (IG)

·

Evaporator temperature: 0°C (32°F)


1.7 to 2.1 V
·

Power switch on (IG)

·

Evaporator temperature: 15°C (59°F)


0.9 to 1.3 V

*: w/ Ion Generator


a.
E338778N01
2.823,1.24 3.281,1.438 0.458,0.198 10 false GND

Waveform 1:

Item Content
Terminal No. K54-6 (BLW) - K54-4 (GND)
Tool Setting 2 V/DIV., 1 ms./DIV.
Condition
·

Power switch on (IG)

·

Blower switch: LO




b.
E334619N02
0.313,1.563 0.771,1.76 0.458,0.198 10 false GND

Waveform 2:

Item Content
Terminal No. K54-14 (LIN1) - K54-4 (GND)
Tool Setting 2 V/DIV., 20 ms./DIV.
Condition Power switch on (IG)


c.
E202803N05
0.333,1.469 0.75,1.646 0.417,0.177 10 GND

Waveform 3:

Item Content
Terminal No. z11-3 (BUS) - z11-2 (BUS G)
Tool Setting 2 V/DIV., 2 ms./DIV.
Condition Power switch on (IG)



CHECK AIR CONDITIONING CONTROL PANEL (RADIO AND DISPLAY RECEIVER ASSEMBLY) (for 8 Inch Display)


E368074N04
3.375,0.208 3.75,0.427 0.375,0.219 3.5,0.24 3.958,0.438 0.458,0.198 10 false h1

HINT:

Check from the rear of the connector while it is connected to the air conditioning control panel (radio and display receiver assembly).


Terminal No.
(Symbol)
Wiring Color Terminal Description Condition Specified Condition
h1-2 (IG+) - h1-6 (GND) SB - W-B Power source (IG) Power switch off Below 1 V
Power switch on (IG) 11 to 14 V
h1-3 (+B) - h1-6 (GND) G - W-B Power source (Back-up) Power switch off 11 to 14 V
h1-6 (GND) - Body ground W-B - Body ground Ground for air conditioning control panel (radio and display receiver assembly) Always Below 1 V
h1-10 (ACC) - h1-6 (GND) R - W-B Power source (ACC) Power switch off Below 1 V
Power switch on (ACC) 11 to 14 V
h1-11 (ILL+) - Body ground W - Body ground Illumination signal Light control switch in off position Below 1 V
Light control switch in tail or head position 11 to 14 V
h1-15 (ILL-) - Body ground L - Body ground Illumination signal Always Below 1 V


CHECK AIR CONDITIONING CONTROL ASSEMBLY (except 8 Inch Display)


E368074N05
3.375,0.208 3.75,0.427 0.375,0.219 3.448,0.24 3.906,0.438 0.458,0.198 10 false K26

HINT:

Check from the rear of the connector while it is connected to the air conditioning control assembly.


Terminal No.
(Symbol)
Wiring Color Terminal Description Condition Specified Condition
K26-2 (IG+) - K26-6 (GND) GR - W-B Power source (IG) Power switch off Below 1 V
Power switch on (IG) 11 to 14 V
K26-6 (GND) - Body ground W-B - Body ground Ground for air conditioning control assembly Always Below 1 V
K26-9 (LIN1) - Body ground LG - Body ground LIN communication signal Power switch on (IG) Pulse generation
(See waveform)
K26-11 (ILL+) - Body ground W - Body ground Illumination signal Light control switch in off position Below 1 V
Light control switch in tail or head position 11 to 14 V
K26-15 (ILL-) - Body ground B - Body ground Illumination signal Always Below 1 V

a.
E202803N05
0.333,1.469 0.75,1.646 0.417,0.177 10 GND

Waveform:

Item Content
Terminal No. K26-9 (LIN1) - Body ground
Tool Setting 2 V/DIV., 20 ms./DIV.
Condition Power switch on (IG)



COOLER CONTROL SWITCH ASSEMBLY (for 3 Zone Type)


E381437N01
3.26,0.354 3.719,0.573 0.458,0.219 3.406,0.406 3.719,0.604 0.313,0.198 10 false Z1

Terminal No.
(Symbol)
Wiring Color Terminal Description Condition Specified Condition
Z1-1 (ACC) - Z1-16 (GND) GR - W-B Power source (ACC) Power switch off Below 1 V
Power switch on (ACC) 11 to 14 V
Z1-9 (+B) - Z1-16 (GND) R - W-B Power source (+B) Power switch off 11 to 14 V
Z1-10 (IG+) - Z1-16 (GND) L - W-B Power source (IG) Power switch off Below 1 V
Power switch on (IG) 11 to 14 V
Z1-11 (ILL+) - Body ground G - Body ground Illumination signal Light control switch in off position Below 1 V
Light control switch in tail or head position 11 to 14 V
Z1-13 (RLIN) - Body ground L - Body ground LIN communication signal Power switch on (IG) Pulse generation
(See waveform)
Z1-16 (GND) - Body ground W-B - Body ground Ground Always Below 1 V

a.
E202803N05
0.333,1.469 0.75,1.646 0.417,0.177 10 GND

Waveform:

Item Content
Terminal No. Z1-13 (RLIN) - Body ground
Tool Setting 2 V/DIV., 20 ms./DIV.
Condition Power switch on (IG)