Home › Engine / Hybrid System › CRUISE CONTROL › ROAD SIGN ASSIST SYSTEM › 2019.02–2021.02
RM33C0E _51 Engine / Hybrid System _065434 CRUISE CONTROL _0383394 ROAD SIGN ASSIST SYSTEM T

CRUISE CONTROL  ROAD SIGN ASSIST SYSTEM  PROBLEM SYMPTOMS TABLE  


NOTICE:
·

When replacing the forward recognition camera, always replace it with a new one. If a forward recognition camera which was installed to another vehicle is used, the information stored in the forward recognition camera will not match the information from the vehicle. As a result, a DTC may be stored.

·

If the forward recognition camera has been replaced with a new one, be sure to perform forward recognition camera adjustment.

Click hereEngine / Hybrid System>CRUISE CONTROL>FRONT CAMERA>ADJUSTMENT (SEQUENTIAL RECOGNITION)

·

When replacing the combination meter assembly, make sure to replace it with a new one.



HINT:

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table.

Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.


Road Sign Assist System
Symptom Suspected Area Link
"Front Camera Unavailable" is displayed The forward recognition camera temperature is extremely high and the system does not operate. When the temperature returns to normal, operation returns to normal (high temperature history can be checked using the Data List). Click here
Forward recognition camera Click here
Combination meter assembly Click here
"Front Camera Vision Blocked Clean and Demist Windshield" is displayed The forward recognition camera cannot detect objects due to dirt. When dirt is removed, operation returns to normal (blockage history can be checked using the Data List). Click here
Forward recognition camera Click here
Combination meter assembly Click here