Home › Audio / Visual / Telematics › TELEMATICS › TELEMATICS SYSTEM (for eCall) › 2019.02–2021.02
RM33C0E _56 Audio / Visual / Telematics _078700 TELEMATICS _0387130 TELEMATICS SYSTEM(for eCall) C

TELEMATICS  TELEMATICS SYSTEM(for eCall)  B1571  Green LED Error  


DESCRIPTION

This DTC is stored when the telematics transceiver detects an open or short in the manual (SOS) switch indicator (green) circuit of the manual (SOS) switch.

The manual (SOS) switch indicator (green) illuminates after the power switch is turned on (IG).

If the telematics system is not active, the manual (SOS) switch indicator (green) will turn off.

If the telematics system is active, the manual (SOS) switch indicator (green) will blink while communicating with the call center.

DTC No. Detection Item DTC Detection Condition Trouble Area
B1571 Green LED Error Current for the manual (SOS) switch indicator (green) exceeds malfunction threshold for 10 seconds or more when the power switch is on (IG)
·

Telematics transceiver

·

Roof console box sub-assembly (manual (SOS) switch)

·

Harness or connector



WIRING DIAGRAM

E342832E47
1.771,1.021 2.365,1.219 0.594,0.198 10 false GREEN 3.396,0.656 3.552,0.854 0.156,0.198 10 false 8 3.406,1.073 3.865,1.344 0.458,0.271 10 false 12 3,0.656 3.615,0.854 0.615,0.198 10 false IND2 2.938,1.073 3.552,1.271 0.615,0.198 10 false GND3 1.24,1.729 1.698,1.927 0.458,0.198 10 false V18 1.24,1.906 3.271,2.354 2.031,0.448 10 false Roof Console Box Sub-assembly (Manual (SOS) Switch) 4.927,0.667 5.24,0.865 0.313,0.198 10 false 12 4.927,1.073 5.24,1.271 0.313,0.198 10 false 26 5.167,0.781 5.781,0.979 0.615,0.198 10 false IND2 5.167,1.073 5.781,1.271 0.615,0.198 10 false SIG- 5.104,1.729 5.563,1.927 0.458,0.198 10 false K157 5.115,1.917 6.573,2.125 1.458,0.208 10 false Telematics Transceiver

CAUTION / NOTICE / HINT

NOTICE:

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Registration for Telematics System.

Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS SYSTEM (for eCall)>REGISTRATION


PROCEDURE

1.CHECK DTC
a.

Turn the power switch off.


b.

Connect the GTS to the DLC3.


c.

Turn the power switch on (IG) and wait for 10 seconds or more.


d.

Turn the GTS on.


e.

Clear the DTCs.

Body Electrical > Telematics > Clear DTCs
50002 233

f.

Check for DTCs and check that no DTCs are output.

Body Electrical > Telematics > Trouble Codes
50001 233
OK:

No DTCs are output.



Result:
Proceed to
OK
NG



OK

NG

2.INSPECT ROOF CONSOLE BOX SUB-ASSEMBLY (MANUAL (SOS) SWITCH) (INPUT VOLTAGE)
2.INSPECT ROOF CONSOLE BOX SUB-ASSEMBLY (MANUAL (SOS) SWITCH) (INPUT VOLTAGE)
a.
B234642C24
2.177,1.292 2.469,1.729 false 1.375,1.135 1.958,1.813 false 0.083,0.063 0.313,0.313 0.229,0.25 10 false *a 2.51,1.677 3.01,1.906 0.5,0.229 10 false GND3 2.01,1.74 2.448,1.99 0.438,0.25 10 false IND2
*a Component with harness connected
(Roof Console Box Sub-assembly (Manual (SOS) Switch))


Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
8 (IND2) - 12 (GND3) 2 seconds after power switch turned on (IG)
→ Power switch off
8.5 to 10 V
→ Below 1 V



Result:
Proceed to
OK
NG



OK

3.INSPECT ROOF CONSOLE BOX SUB-ASSEMBLY (MANUAL (SOS) SWITCH) (GREEN INDICATOR)

NG

4.CHECK HARNESS AND CONNECTOR (TELEMATICS TRANSCEIVER - ROOF CONSOLE BOX SUB-ASSEMBLY (MANUAL (SOS) SWITCH))
3.INSPECT ROOF CONSOLE BOX SUB-ASSEMBLY (MANUAL (SOS) SWITCH) (GREEN INDICATOR)
a.
B129570C38
1.552,1.802 1.24,1.125 false 2.583,1.781 2.417,1.323 false 0.073,0.094 0.354,0.333 0.281,0.24 10 false *a 2.635,1.719 3.198,1.969 0.563,0.25 10 false GND3 1.604,1.729 2.042,1.938 0.438,0.208 10 false IND2
*a Component without harness connected
(Roof Console Box Sub-assembly (Manual (SOS) Switch))


Remove the roof console box sub-assembly (manual (SOS) switch).

Click hereVehicle Interior>LIGHTING (INT)>PERSONAL LIGHT>REMOVAL


b.

Connect 2 dry-cell batteries (1.5 V each) in series.


c.

Connect a positive (+) lead from batteries to terminal 8 (IND2) and a negative (-) lead to terminal 12 (GND3) of the roof console box sub-assembly (manual (SOS) switch) connector.


d.

Check if the manual (SOS) switch indicator (green) comes on.

OK:

Manual (SOS) switch indicator (green) illuminates.



Result:
Proceed to
OK
NG



OK

4.CHECK HARNESS AND CONNECTOR (TELEMATICS TRANSCEIVER - ROOF CONSOLE BOX SUB-ASSEMBLY (MANUAL (SOS) SWITCH))

NG

REPLACE ROOF CONSOLE BOX SUB-ASSEMBLY (MANUAL (SOS) SWITCH)

4.CHECK HARNESS AND CONNECTOR (TELEMATICS TRANSCEIVER - ROOF CONSOLE BOX SUB-ASSEMBLY (MANUAL (SOS) SWITCH))
a.

Disconnect the K157 telematics transceiver connector.


b.

Disconnect the V18 roof console box sub-assembly (manual (SOS) switch) connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
K157-12 (IND2) - V18-8 (IND2) Always Below 1 Ω
K157-12 (IND2) or V18-8 (IND2) - Body ground Always 10 kΩ or higher
K157-26 (SIG-) - V18-12 (GND3) Always Below 1 Ω
K157-26 (SIG-) or V18-12 (GND3) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

5.REPLACE TELEMATICS TRANSCEIVER

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

5.REPLACE TELEMATICS TRANSCEIVER
a.

Replace the telematics transceiver with a new one.

Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS TRANSCEIVER>REMOVAL


Result:
Proceed to
NEXT



NEXT