This DTC is stored when the clearance warning ECU assembly receives a signal from the blind spot monitor system via CAN communication indicating a malfunction in the blind spot monitor sensor.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1AF7 | RCTB Sensor | Blind spot monitor sensor malfunction | Blind spot monitor system |
Using the GTS, check for DTCs according to the prompts on the screen.
After turning the power switch from off to on (IG), wait 4 seconds or more before checking for DTCs.
Clear the DTCs according to the screen on the GTS.
Recheck for DTCs.
DTC C1AF7 is stored when a malfunction signal sent from the blind spot monitor system is detected.
If the malfunctioning part has been repaired or replaced before rechecking for DTCs, DTC C1AF7 will not be output again.
If DTC C1AF7 is output frequently, duplicate the conditions that cause the problem symptoms and perform the inspection again, even though the DTC was not output when rechecking for DTCs.
| Result | Proceed to |
|---|---|
| DTC C1AF7 is output | A |
| DTC C1AF7 is not output | B |
A
B
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING