Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › PARKING SUPPORT BRAKE SYSTEM › 2019.02–2021.02
RM33C0E _56 Audio / Visual / Telematics _065452 PARK ASSIST / MONITORING _0387691 PARKING SUPPORT BRAKE SYSTEM C

PARK ASSIST / MONITORING  PARKING SUPPORT BRAKE SYSTEM  C1AF9  Blind Spot Monitor Beam Axis Inspection Incomplete  


DESCRIPTION

This DTC is stored when the clearance warning ECU assembly receives a signal from the blind spot monitor system via CAN communication indicating that the beam axis inspection is incomplete.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1AF9 Blind Spot Monitor Beam Axis Inspection Incomplete The clearance warning ECU assembly receives a signal indicating that the beam axis inspection is incomplete. Blind spot monitor system

PROCEDURE

1.CHECK FOR DTC
a.

Using the GTS, check for DTCs according to the prompts on the screen.

HINT:

After turning the power switch from off to on (IG), wait 4 seconds or more before checking for DTCs.


Body Electrical > IPA/ICS/Clearance Sonar > Trouble Codes
50001 170

b.

Clear the DTCs according to the screen on the GTS.

Body Electrical > IPA/ICS/Clearance Sonar > Clear DTCs
50002 170

c.

Recheck for DTCs.

Body Electrical > IPA/ICS/Clearance Sonar > Trouble Codes
50001 170
HINT:
·

DTC C1AF9 is stored when a malfunction signal sent from the blind spot monitor system is detected.

·

If the malfunctioning part has been repaired or replaced before rechecking for DTCs, DTC C1AF9 will not be output again.

·

If DTC C1AF9 is output frequently, duplicate the conditions that cause the problem symptoms and perform the inspection again, even though the DTC was not output when rechecking for DTCs.

Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING




Result:
Result Proceed to
DTC C1AF9 is output A
DTC C1AF9 is not output B



A

B