The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during mobile phone battery removal/installation are shown below.
1. PRECAUTION
86740
2.REMOVE TELEMATICS TRANSCEIVER
86725
3.REMOVE MOBILE PHONE BATTERY
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
Disengage the claw and 2 guides as shown in the illustration to remove the transceiver cover.
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
Disconnect the connector.
Disengage the 4 guides and remove the mobile phone battery as shown in the illustration.