88211B
1.REMOVE MILLIMETER WAVE RADAR SENSOR ASSEMBLY (w/ Pre-collision System)
52114A
2.REMOVE FRONT BUMPER EXTENSION MOUNTING BRACKET (for Bar Type Radiator Grille)
Remove the 2 screws.
|
Remove in this Direction |
Disengage the 4 claws to remove the front bumper extension mounting bracket as shown in the illustration.
52114A
3.REMOVE FRONT BUMPER EXTENSION MOUNTING BRACKET (for Mesh Type Radiator Grille)
Remove the 2 screws.
|
Remove in this Direction |
Disengage the 2 claws and 4 guides to remove the front bumper extension mounting bracket as shown in the illustration.
52423A
4.REMOVE FRONT BUMPER PAD LH (for Bar Type Radiator Grille)
Disengage the 2 claws and guide to remove the front bumper pad LH.
52422A
5.REMOVE FRONT BUMPER PAD RH (for Bar Type Radiator Grille)
Use the same procedure as for the LH side.
52423A
6.REMOVE FRONT BUMPER PAD LH (for Mesh Type Radiator Grille)
Disengage the 2 claws and guide to remove the front bumper pad LH.
52422A
7.REMOVE FRONT BUMPER PAD RH (for Mesh Type Radiator Grille)
Use the same procedure as for the LH side.
89341K
8.REMOVE FRONT CORNER ULTRASONIC SENSOR (w/ TOYOTA Parking Assist-sensor System)
w/o Parking Support Brake System:
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>ULTRASONIC SENSOR (for Front)>REMOVAL
w/ Parking Support Brake System:
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>ULTRASONIC SENSOR (for Front)>REMOVAL
89347B
9.REMOVE FRONT CORNER ULTRASONIC SENSOR RETAINER (w/ TOYOTA Parking Assist-sensor System)
w/o Parking Support Brake System:
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>ULTRASONIC SENSOR (for Front)>REMOVAL
w/ Parking Support Brake System:
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>ULTRASONIC SENSOR (for Front)>REMOVAL
89341L
10.REMOVE FRONT CENTER ULTRASONIC SENSOR (w/ TOYOTA Parking Assist-sensor System)
w/ Parking Support Brake System:
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>ULTRASONIC SENSOR (for Front)>REMOVAL
89347C
11.REMOVE FRONT CENTER ULTRASONIC SENSOR RETAINER (w/ TOYOTA Parking Assist-sensor System)
w/ Parking Support Brake System:
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>ULTRASONIC SENSOR (for Front)>REMOVAL
82114
12.REMOVE NO. 4 ENGINE ROOM WIRE (w/ TOYOTA Parking Assist-sensor System)
for Bar Type Radiator Grille:
w/o Parking Support Brake System:
Disengage the 10 clamps to remove the No. 4 engine room wire.
w/ Parking Support Brake System:
Disengage the 12 clamps to remove the No. 4 engine room wire.
for Mesh Type Radiator Grille:
Disengage the 12 clamps to remove the No. 4 engine room wire.
85354
13.REMOVE HEADLIGHT WASHER COVER LH (w/ Headlight Cleaner System)
85353
14.REMOVE HEADLIGHT WASHER COVER RH (w/ Headlight Cleaner System)
Use the same procedure as for the LH side.
85208A
15.REMOVE HEADLIGHT WASHER ACTUATOR SUB-ASSEMBLY LH (w/ Headlight Cleaner System)
85207A
16.REMOVE HEADLIGHT WASHER ACTUATOR SUB-ASSEMBLY RH (w/ Headlight Cleaner System)
Use the same procedure as for the LH side.
17.REMOVE HEADLIGHT CLEANER HOSE (w/ Headlight Cleaner System)
Disengage the 7 clamps to remove the headlight cleaner hose.
52128B
18.REMOVE FRONT BUMPER HOLE COVER LH (for Bar Type Radiator Grille)
| *a | Hook |
|
Remove in this Direction |
Disengage the 4 claws as shown in the illustration.
Disengage the hook to remove the front bumper hole cover LH.
52128B
19.REMOVE FRONT BUMPER HOLE COVER LH (for Mesh Type Radiator Grille)
| *a | Hook |
|
Remove in this Direction |
Disengage the 6 claws as shown in the illustration.
Disengage the hook to remove the front bumper hole cover LH.
52127D
20.REMOVE FRONT BUMPER HOLE COVER RH (for Mesh Type Radiator Grille)
Use the same procedure as for the LH side.
53395E
21.REMOVE HOOD TO FRONT END PANEL SEAL
Disengage the 6 clips.
|
Double-sided Tape |
Separate the double-sided tape and disengage the guide to remove the hood to front end panel seal.
75310A
22.REMOVE RADIATOR GRILLE EMBLEM ASSEMBLY
Remove the 2 screws.
Disengage the 2 claws and guide to remove the radiator grille emblem assembly.
53124B
23.REMOVE RADIATOR GRILLE SIDE MOULDING LH (for Bar Type Radiator Grille)
Remove the screw.
|
Remove in this Direction |
Disengage the 3 claws to remove the radiator grille side moulding LH as shown in the illustration.
53123B
24.REMOVE RADIATOR GRILLE SIDE MOULDING RH (for Bar Type Radiator Grille)
Use the same procedure as for the LH side.
53111
25.REMOVE RADIATOR GRILLE (for Bar Type Radiator Grille)
Remove the 2 clips.
Remove the 6 screws and radiator grille.
53111
26.REMOVE RADIATOR GRILLE (for Mesh Type Radiator Grille)
Remove the 2 clips.
Remove the 10 screws and radiator grille.
81220
27.REMOVE FOG LIGHT ASSEMBLY LH (w/ Fog Light)
81210A
28.REMOVE FOG LIGHT ASSEMBLY RH (w/ Fog Light)
Use the same procedure as for the LH side.
53123D
29.REMOVE LOWER RADIATOR GRILLE MOULDING (for Mesh Type Radiator Grille)
Remove the 2 screws.
Disengage the 16 claws to remove the lower radiator grille moulding.
53124D
30.REMOVE LOWER RADIATOR GRILLE MOULDING LH (for Mesh Type Radiator Grille)
Disengage the 10 claws to remove the lower radiator grille moulding LH.
53123C
31.REMOVE LOWER RADIATOR GRILLE MOULDING RH (for Mesh Type Radiator Grille)
Use the same procedure as for the LH side.
81482C
32.REMOVE FOG LIGHT COVER LH (for Mesh Type Radiator Grille)
Disengage the 6 claws to remove the fog light cover LH.
81481E
33.REMOVE FOG LIGHT COVER RH (for Mesh Type Radiator Grille)
Use the same procedure as for the LH side.
53102A
34.REMOVE LOWER RADIATOR GRILLE SUB-ASSEMBLY (for Bar Type Radiator Grille)
Remove the 6 screws.
Disengage the 23 claws to remove the lower radiator grille sub-assembly.
53102A
35.REMOVE LOWER RADIATOR GRILLE SUB-ASSEMBLY (for Mesh Type Radiator Grille)
Remove the 2 screws.
Disengage the 18 claws to remove the lower radiator grille sub-assembly.
53124B
36.REMOVE RADIATOR GRILLE SIDE MOULDING LH (for Mesh Type Radiator Grille)
Remove the 2 clips.
Disengage the 2 claws and 2 guides to remove the radiator grille side moulding LH.
53123B
37.REMOVE RADIATOR GRILLE SIDE MOULDING RH (for Mesh Type Radiator Grille)
Use the same procedure as for the LH side.
47749F
38.REMOVE PIN HOLD CLIP
|
Remove in this Direction |
Disengage the 4 claws to remove the 2 pin hold clips as shown in the illustration.
Use the same procedure for the RH side and LH side.
53879H
39.REMOVE FRONT FENDER LINER RETAINER
|
Remove in this Direction |
Remove the 2 front fender liner retainers as shown in the illustration.
Use the same procedure for the RH side and LH side.
52611
40.REMOVE FRONT BUMPER ENERGY ABSORBER
|
Remove in this Direction |
Disengage the 4 guides to remove the front bumper energy absorber as shown in the illustration.
52131A
41.REMOVE FRONT BUMPER REINFORCEMENT
Remove the headlight assembly LH.
Click hereVehicle Exterior>LIGHTING (EXT)>HEADLIGHT ASSEMBLY (for LED Type Turn Signal Light)>REMOVAL
Remove the headlight assembly RH.
Use the same procedure as for the LH side.
Disengage the 5 clamps.
Remove the 6 bolts and front bumper reinforcement.
52536
42.REMOVE FRONT BUMPER SIDE RETAINER LH
Remove the bolt.
|
Remove in this Direction |
Disengage the 2 clips to remove the front bumper side retainer LH as shown in the illustration.
52535
43.REMOVE FRONT BUMPER SIDE RETAINER RH
Use the same procedure as for the LH side.