1.INSTALL REAR BUMPER ASSEMBLY
Connect the connector.
|
Install in this Direction |
Engage the 2 guides and 4 claws as shown in the illustration.
|
Install in this Direction |
Engage the 6 claws as shown in the illustration.
Use the same procedure for the RH side and LH side.
Install the 2 screws.
Install the rear bumper assembly with the 11 clips.
81498
2.INSTALL REAR COMBINATION LIGHT COVER LH
81497
3.INSTALL REAR COMBINATION LIGHT COVER RH
Use the same procedure as for the LH side.
4.PERFORM CALIBRATION (w/ TOYOTA Parking Assist-sensor System)
w/ Parking Support Brake System