This DTC is stored when a malfunction is detected in the starter circuit inside the certification ECU (smart key ECU assembly).
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Note |
|---|---|---|---|---|
| B2275 | STSW Monitor Malfunction | Certification ECU (smart key ECU assembly) internal HV activation request output circuit malfunction or external circuit malfunction (1-trip detection logic*) | ·
Certification ECU (smart key ECU assembly) ·
Hybrid vehicle control ECU assembly ·
Wire harness or connector |
DTC Output Confirmation Operation:
Turn the power switch on (IG) and wait 10 seconds or more, then start the hybrid control system 3 times. |
*: Only detected while a malfunction is present and the power switch is on (IG).
| Vehicle Condition when Malfunction Detected | Fail-safe Function when Malfunction Detected |
|---|---|
·
The power source mode changes to on (READY) even though the hybrid control system is not started. ·
The power source mode does not change to on (READY) even though the hybrid control system is started. |
- |
| DTC No. | Data List and Active Test |
|---|---|
| B2275 | Power Source Control
·
Starter Request Signal |
When using the GTS with the power switch off, connect the GTS to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the GTS and the vehicle begins. Then select Model Code "KEY REGIST" under manual mode and enter the following menus: Body Electrical / Entry&Start(CAN). While using the GTS, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the GTS and the vehicle.
The entry and start system (for Start Function) uses the LIN communication system and CAN communication system. Inspect the communication function by following How to Proceed with Troubleshooting. Troubleshoot the entry and start system (for Start Function) after confirming that the communication systems are functioning properly.
Before replacing the hybrid vehicle control ECU assembly or certification ECU (smart key ECU assembly), refer to Service Bulletin.
After repair, confirm that no DTCs are output by performing "DTC Output Confirmation Operation".
Turn the power switch on (IG) and wait 25 seconds.
Using the GTS, check for certification ECU (smart key ECU assembly) DTCs.
DTC B2285 is not output simultaneously.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENTRY AND START SYSTEM (for Start Function)>B2285
Disconnect the K62 certification ECU (smart key ECU assembly) connector.
Disconnect the K69 hybrid vehicle control ECU assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| K62-27 (ST2) - K69-9 (ST2) | Always | Below 1 Ω |
| K62-27 (ST2) or K69-9 (ST2) - Other terminals and body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Reconnect the K62 certification ECU (smart key ECU assembly) connector.
Reconnect the K69 hybrid vehicle control ECU assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| K62-27 (ST2) - Body ground | With the brake pedal depressed, the power switch is pressed and held → After approx. 3 sec. has elapsed, the power switch is released | 8.5 V or higher → 1 V or less |
| Proceed to |
|---|
| OK |
| NG |
OK
NG