Home › Vehicle Interior › HEATING / AIR CONDITIONING › BLOWER UNIT › 2019.02–2021.02
RM33C0E _58 Vehicle Interior _065464 HEATING / AIR CONDITIONING _0331709 BLOWER UNIT A

HEATING / AIR CONDITIONING  BLOWER UNIT  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during blower unit removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function When Necessary Procedures are not Performed Link

*: When performing learning using the GTS

Click here(Click here)

Disconnect cable from negative (-) auxiliary battery terminal Perform steering sensor zero point calibration Lane departure alert system (w/ steering control) (Click here)
Parking Support Brake System*
Pre-collision system
Memorize steering angle neutral point Parking assist monitor system (Click here)
Steering sensor Steering angle neutral point (Initialize parking assist monitor system) Parking assist monitor system (Click here)
Parking support brake system (Click here)
Steering angle setting Parking assist monitor system (Click here)

CAUTION:
B401522

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION


HINT:

Before removing the blower assembly, set the air conditioning to recirculation mode.


PROCEDURE

Hide 1.REMOVE AIR CONDITIONER UNIT ASSEMBLY

Hide 87130D 3.REMOVE BLOWER ASSEMBLY

a.

for LHD:

i.
E372594C01
0.167,2.167 0.417,2.417 0.25,0.25 12 true *A 1.833,2.167 2.083,2.417 0.25,0.25 12 true *B
*A for 1-tier Type
*B for 2-tier Type


Disconnect the connector.


ii.

Disengage each guide.


iii.
E372595

Remove the 2 screws.


iv.

Disengage the 2 claws and 2 guides and remove the blower assembly from the air conditioning radiator assembly.



b.

for RHD:

i.
E371369

Disconnect the connector.


ii.

Disengage each guide.


iii.
E372600

Remove the 2 screws.


iv.

Disengage the 2 claws and 2 guides and remove the blower assembly from the air conditioning radiator assembly.