Home › Steering › STEERING COLUMN › TILT AND TELESCOPIC MANUAL SWITCH › 2019.02–2021.02
RM33C0E _55 Steering _065448 STEERING COLUMN _0334242 TILT AND TELESCOPIC MANUAL SWITCH A

STEERING COLUMN  TILT AND TELESCOPIC MANUAL SWITCH  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during tilt and telescopic switch removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Auxiliary battery terminal is disconnected/reconnected Perform steering sensor zero point calibration Lane Departure Alert System (w/ Steering Control) (Click here)
Parking Support Brake System
Pre-collision System
Memorize steering angle neutral point Parking Assist Monitor System (Click here)

PROCEDURE

Hide 1. CHANGE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM SETTINGS

Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Click hereGeneral>MAINTENANCE>AUXILIARY BATTERY>REMOVAL

CAUTION:
B422343

Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 45024 3.REMOVE LOWER STEERING COLUMN COVER SUB-ASSEMBLY

Hide 89235A 4.REMOVE TILT AND TELESCOPIC SWITCH

a.
C379369C01
0.479,1.594 0.604,1.594 0.604,1.594 1.135,1.385 true 1.688,0.667 2.104,0.271 2.104,0.271 2.198,0.271 true 2.24,0.177 2.427,0.354 0.188,0.177 10 true *1 0.313,1.51 0.479,1.688 0.167,0.177 10 true *2
*1 Spiral Cable Connector
*2 Tilt and Telescopic Connector


Disconnect the spiral cable connector from the spiral cable sub-assembly.


b.

Disconnect the tilt and telescopic connector from the tilt and telescopic switch.


c.
C379370

Disengage the claw and pull out the tilt and telescopic switch.