Home › Vehicle Interior › SEAT › REAR SEAT RECLINING CONTROL CABLE › 2019.02–2021.02
RM33C0E _58 Vehicle Interior _065462 SEAT _0333618 REAR SEAT RECLINING CONTROL CABLE A

SEAT  REAR SEAT RECLINING CONTROL CABLE  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during rear seatback lock assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

*: When performing learning using the GTS

Click here(Click here)

Disconnect cable from negative auxiliary battery terminal Perform steering sensor zero point calibration Lane Departure Alert System (w/ Steering Control) (Click here)
Parking Support Brake System*
Pre-collision System
Memorize steering angle neutral point Parking Assist Monitor System (Click here)

CAUTION:
·

Wear protective gloves. Sharp areas on the parts may injure your hands.

·
B401522

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION



PROCEDURE

Hide 64770 1.REMOVE SPARE WHEEL COVER ASSEMBLY

Hide 81006 3.REMOVE CENTER STOP LIGHT SET

Hide 64727A 4.REMOVE LUGGAGE COMPARTMENT TRIM INNER PAD

a.
B470161

Remove the luggage compartment trim inner pad.


Hide 73370E 5.DISCONNECT REAR SEAT OUTER BELT ASSEMBLY LH

Hide 73360D 6.DISCONNECT REAR SEAT OUTER BELT ASSEMBLY RH

HINT:

Use the same procedure as for the LH side.


Hide 62472A 7.REMOVE INNER ROOF SIDE GARNISH LH

Hide 62471A 8.REMOVE INNER ROOF SIDE GARNISH RH

HINT:

Use the same procedure as for the LH side.


Hide 73373F 9.REMOVE REAR SEAT SHOULDER BELT HOLE COVER

Hide 64330 10.REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY (w/o Rear Sunshade)

a.
B470185

Remove the 2 clips.


b.
B472991

Disengage the 3 clips and 5 guides.


c.

Pass the 3 rear seat belt floor anchors through the package tray trim panel assembly then remove the package tray trim panel assembly.


Hide 64330 11.REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY (w/ Rear Sunshade)

Hide 64272B 12.REMOVE ROOM PARTITION BOARD LH

a.
B470162

Remove the clip.


b.
B474159

Disengage the 2 claws.


c.

Disengage the 4 clips to remove the room partition board LH.


Hide 64271G 13.REMOVE ROOM PARTITION BOARD RH

a.
B470164

Remove the 2 clips.


b.
B474158

Disengage the 5 clips to remove the room partition board RH.


Hide 72640A 14.REMOVE REAR SEATBACK LOCK ASSEMBLY LH

a.
B470166C01
2.021,0.74 2.396,0.76 false 2.427,0.677 2.656,0.854 0.229,0.177 10 false *a
*a Stopper
V100135

Release
V113147

Remove in this Direction (1)
V113148

Remove in this Direction (2)


Release the stopper and disengage the guide as shown in the illustration.


b.
B473438

Remove the 2 nuts and rear seatback lock assembly LH.


Hide 72630C 15.REMOVE REAR SEATBACK LOCK ASSEMBLY RH

HINT:

Use the same procedure as for the LH side.