The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front door window frame moulding removal/installation are shown below.
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
75720
1.REMOVE FRONT DOOR BELT MOULDING ASSEMBLY
67856B
2.REMOVE FRONT DOOR PANEL PROTECTOR
68151C
3.REMOVE FRONT DOOR GLASS RUN
67862
4.DISCONNECT FRONT DOOR WEATHERSTRIP
Disengage the 2 clips and disconnect the front door weatherstrip.
75756C
5.REMOVE FRONT DOOR REAR WINDOW FRAME MOULDING
When removing the front door rear window frame moulding, heat the vehicle body and front door rear window frame moulding using a heat light.
| Item | Temperature |
|---|---|
| Vehicle Body | 40 to 60°C (104 to 140°F) |
| Front Door Rear Window Frame Moulding | 20 to 30°C (68 to 86°F) |
| *a | Heated Part |
| *b | Heat Light |
Do not touch the heat light and heated parts, touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
Do not heat the vehicle body or front door rear window frame moulding excessively.
Using a heat light, heat the front door rear window frame moulding.
| *a | Double-sided Tape |
| *b | Caulking Sponge |
Using a moulding remover, disengage the clip and separate the double-sided tape and caulking sponge to remove the front door rear window frame moulding.
75754A
6.REMOVE FRONT DOOR UPPER WINDOW FRAME MOULDING
Insert a 4.0 mm (0.157 in.) drill bit into a drill.
| *a | Tape |
Tape the 4.0 mm (0.157 in.) drill bit 5.0 mm (0.197 in.) from the tip as shown in the illustration.
| Area | Measurement |
|---|---|
| A | 5.0 mm (0.197 in.) |
Tape the 4.0 mm (0.157 in.) drill bit to prevent the drill bit from going too deep.
Lightly press the drill bit against the rivets to drill off the rivet flanges, and remove the 7 rivets.
| *a | Clamp | *b | Guide |
Be careful of the drilled rivets, as they may be hot.
Pressing the drill too firmly will cause the rivet to turn and result in the rivet not being drilled through.
Prying the rivets with the drill may damage the rivet installation holes or drill bit.
Using a vacuum cleaner, remove the rivet fragments and shavings from the drilled areas.
Disengage the clamp and guide to remove the front door upper window frame moulding from the door frame.