Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE PEDAL (for LHD) › 2019.02–2021.02
RM33C0E _54 Brake _065443 BRAKE SYSTEM (OTHER) _0319349 BRAKE PEDAL(for LHD) A

BRAKE SYSTEM (OTHER)  BRAKE PEDAL(for LHD)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during brake pedal support assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

*: When performing learning using the GTS

Click here(Click here)

Auxiliary battery terminal is disconnected/reconnected Perform steering sensor zero point calibration Lane Departure Alert System (w/ Steering Control) (Click here)
Parking Support Brake System*
Pre-collision System
Memorize steering angle neutral point Parking Assist Monitor System (Click here)
Replacement of brake pedal support assembly
1.

Clear the data stored during previous linear solenoid valve offset learning, ABS holding solenoid valve learning, brake pedal stroke sensor assembly zero point calibration and system information memorization.

2.

Perform linear solenoid valve offset learning, ABS holding solenoid valve learning, brake pedal stroke sensor assembly zero point calibration and system information memorization.


·

DTCs are stored

·

ABS warning light illuminates

·

Brake warning light / yellow (minor malfunction) illuminates

·

Slip indicator light illuminates

·

VSC disabled or malfunctions


(Click here)for Initialization
(Click here)for Calibration

CAUTION / NOTICE / HINT

NOTICE:

While the auxiliary battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or any door courtesy switch turns on. Therefore, when servicing the brake system components, do not operate the brake pedal or open/close the doors while the auxiliary battery is connected.


PROCEDURE

Hide 47210L 1.REMOVE BRAKE BOOSTER WITH MASTER CYLINDER ASSEMBLY

Hide 89510D 2.REMOVE BRAKE PEDAL STROKE SENSOR ASSEMBLY

Hide 84340 3.REMOVE STOP LIGHT SWITCH ASSEMBLY

Hide 4.REMOVE BRAKE PEDAL SUPPORT ASSEMBLY

a.
C376578

Disengage the clamp to separate the wire harness from the brake pedal support assembly.


b.
C376579

Remove the bolt and separate the brake pedal support assembly from the instrument panel reinforcement assembly.


c.
C376580

Remove the 2 clips.


d.

Remove the brake pedal support assembly while avoiding the stud bolts of the brake booster support base.

NOTICE:

Be careful not to deform the bracket of the instrument panel reinforcement assembly.



Hide 47101A 5.REMOVE BRAKE PEDAL RETURN SPRING

a.
C376581

Remove the brake pedal return spring from the brake pedal support assembly.


Hide 84345 6.REMOVE STOP LIGHT SWITCH MOUNTING ADJUSTER

a.
C376582

Disengage the 2 claws and remove the stop light switch mounting adjuster.


Hide 47121 7.REMOVE BRAKE PEDAL PAD

a.

Remove the brake pedal pad from the brake pedal support assembly.