Home › Vehicle Interior › HEATING / AIR CONDITIONING › AMBIENT TEMPERATURE SENSOR › 2019.02–2021.02
RM33C0E _58 Vehicle Interior _065464 HEATING / AIR CONDITIONING _0331716 AMBIENT TEMPERATURE SENSOR A

HEATING / AIR CONDITIONING  AMBIENT TEMPERATURE SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during thermistor assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function When Necessary Procedures are not Performed Link
Front bumper assembly (w/ Parking Support Brake System)
·

Measure ultrasonic sensor detection angle

·

Ultrasonic sensor detection angle registration


·

TOYOTA Parking Assist-sensor System

·

Parking Support Brake System


(Click here)

PROCEDURE

Hide 1.REMOVE FRONT BUMPER ASSEMBLY

Hide 16691A 2.REMOVE FRONT RADIATOR SIDE AIR GUIDE PLATE RH (w/o Grille Shutter)

a.
E460789

Disengage the 2 claws to remove the front radiator side air guide plate RH.


Hide 88790B 3.REMOVE THERMISTOR ASSEMBLY (w/o Grille Shutter)

a.
E460790

Disengage the clamp.


b.

Disconnect the connector to remove the thermistor assembly.


Hide 16695A 4.REMOVE FRONT RADIATOR SIDE AIR GUIDE PLATE LH (w/ Grille Shutter)

a.
E371116

Disengage the 2 claws to remove the front radiator side air guide plate LH.


Hide 88790B 5.REMOVE THERMISTOR ASSEMBLY (w/ Grille Shutter)

a.
E372048

Disengage the clamp.


b.

Disconnect the connector to remove the thermistor assembly.