This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
25620
1.SET EGR VALVE ASSEMBLY
Set the EGR valve assembly to the camshaft housing.
At this time, do not install the parts with bolts.
Install the No. 4 water by-pass hose to the EGR valve assembly and slide the clip to secure it.
Connect the No. 8 water by-pass hose to the EGR valve assembly and slide the clip to secure it.
25680
2.INSTALL EGR COOLER ASSEMBLY
25620
3.INSTALL EGR VALVE ASSEMBLY
Using an 8 mm socket wrench, install the EGR valve assembly to the camshaft housing with the 2 bolts.
25601
4.INSTALL NO. 1 EGR PIPE SUB-ASSEMBLY
Install a new EGR inlet gasket to the intake manifold.
Install a new EGR valve adapter gasket to the No. 1 EGR pipe sub-assembly.
Using an 8 mm socket wrench, install the No. 1 EGR pipe sub-assembly to the intake manifold and EGR valve assembly with the 4 bolts.
5.CONNECT ENGINE WIRE
Engage the 2 wire harness clamps to connect the engine wire.
Install the bolt.
Connect the EGR valve assembly connector.
| *1 | No. 1 Fuel Vapor Feed Hose |
| *2 | No. 2 Fuel Vapor Feed Hose |
Engage the 3 hose clamps to connect the No. 1 fuel vapor feed hose and No. 2 fuel vapor feed hose.