When selecting ECO mode, the ECO mode switch (electric parking brake switch assembly) operation signal is sent to the air conditioning amplifier assembly. Following this, ECO mode control is activated for the heater and air conditioning system and the hybrid vehicle control system.
| Result | Proceed to |
|---|---|
| All of the ECUs and sensors that are currently connected to the CAN communication system are displayed | A |
| None of the ECUs and sensors that are currently connected to the CAN communication system are displayed, or some of them are not displayed | B |
A
B
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
| Result | Proceed to |
|---|---|
| No DTCs are output | A |
| DTCs are output | B |
A
B
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Enter the following menus: Body Electrical / Air Conditioner / Data List / ECO Switch.
| Tester Display |
|---|
| ECO Switch |
Read the value displayed on the GTS.
| Result | Proceed to |
|---|---|
| The GTS display changes according to the ECO mode switch (electric parking brake switch assembly) operation | A |
| The GTS display does not change according to the ECO mode switch (electric parking brake switch assembly) operation | B |
A
B
Click hereVehicle Interior>HEATING / AIR CONDITIONING>ECO SWITCH>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the K37 ECO mode switch (electric parking brake switch assembly) connector.
| *A | for LHD |
| *B | for RHD |
| *a | Front view of wire harness connector
(to ECO Mode Switch (Electric Parking Brake Switch Assembly)) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| K37-16 (GND1) - Body ground | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| K37-9 (GND1) - Body ground | Always | Below 1 Ω |
Reconnect the K37 ECO mode switch (electric parking brake switch assembly) connector.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the K55 air conditioning amplifier assembly connector.
Disconnect the K37 ECO mode switch (electric parking brake switch assembly) connector.
| *A | for LHD |
| *B | for RHD |
| *a | Front view of wire harness connector
(to Air Conditioning Amplifier Assembly) |
| *b | Front view of wire harness connector
(to ECO Mode Switch (Electric Parking Brake Switch Assembly)) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| K55-20 (ECOS) - K37-11 (ECU) | Always | Below 1 Ω |
| K55-20 (ECOS) or K37-11 (ECU) - Body ground | Always | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| K55-20 (ECOS) - K37-14 (ECU) | Always | Below 1 Ω |
| K55-20 (ECOS) or K37-14 (ECU) - Body ground | Always | 10 kΩ or higher |
Reconnect the K37 ECO mode switch (electric parking brake switch assembly) connector.
Reconnect the K55 air conditioning amplifier assembly connector.
| Proceed to |
|---|
| OK |
| NG |
OK
NG