Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › PANORAMIC VIEW MONITOR SWITCH › from 2021.02
RM33C0E _56 Audio / Visual / Telematics _065452 PARK ASSIST / MONITORING _0461971 PANORAMIC VIEW MONITOR SWITCH G

PARK ASSIST / MONITORING  PANORAMIC VIEW MONITOR SWITCH  INSPECTION  


PROCEDURE

Hide 84721B 1.INSPECT PANORAMIC VIEW MONITOR SWITCH


b.
E372788C01
1.01,1.906 1.177,1.906 1.177,1.906 1.417,1.49 false 2.542,1.927 2.375,1.927 2.375,1.927 2.021,1.469 false 0.115,0.094 0.427,0.25 0.313,0.156 10 false *a 0.854,1.833 1.167,1.99 0.313,0.156 10 false D 2.625,1.854 2.938,2.01 0.313,0.156 10 false E
*a Component without harness connected
(Panoramic View Monitor Switch)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
5 (D) - 2 (E) Panoramic view monitor switch pushed Below 1 Ω
Panoramic view monitor switch not pushed 1 kΩ or higher


If the result is not as specified, replace the panoramic view monitor switch.


c.

Check that the switch illumination illuminates.

i.
E372788C02
0.885,1.969 1.052,1.969 1.052,1.969 1.24,1.469 false 2.573,1.948 2.406,1.948 2.406,1.948 2.198,1.479 false 0.115,0.094 0.427,0.25 0.313,0.156 10 false *a 0.552,1.885 0.927,2.042 0.375,0.156 10 false ILL+ 2.635,1.865 3.042,2.083 0.406,0.219 10 false ILL-
*a Component without harness connected
(Panoramic View Monitor Switch)


Apply battery voltage to the panoramic view monitor switch and check that the switch illumination illuminates.

OK:
Connection Specified Condition
Battery positive (+) → Terminal 6 (ILL+)
Battery negative (-) → Terminal 1 (ILL-)
Illuminates


If the result is not as specified, replace the panoramic view monitor switch.