Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › TELEVISION CAMERA (for Side) › from 2021.02
RM33C0E _56 Audio / Visual / Telematics _065452 PARK ASSIST / MONITORING _0461974 TELEVISION CAMERA(for Side) A

PARK ASSIST / MONITORING  TELEVISION CAMERA(for Side)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during side television camera assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

*1: Applies only for when removing and installing or replacing the rear television camera assembly.

·

Side television camera assembly LH

·

Side television camera assembly RH


Side television camera view adjustment Panoramic View Monitor System (Click here)
Replacement or removal and installation of 2 or more parts:
·

Front television camera assembly, front bumper assembly or radiator grille

·

Rear television camera assembly

·

Side television camera assembly LH or outer rear view mirror assembly LH

·

Side television camera assembly RH or outer rear view mirror assembly RH


·

Television camera view adjustment

·

Rear television camera assembly optical axis (Back camera position setting)*1



HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 87945 2.REMOVE OUTER MIRROR COVER

Hide 3.REMOVE OUTER MIRROR HOLE COVER WITH SIDE TELEVISION CAMERA ASSEMBLY

Hide 86790F 4.REMOVE SIDE TELEVISION CAMERA ASSEMBLY

a.
E459815

Disengage the 2 guides.


b.
E459816

Remove the screw.


c.

Disengage the claw to remove the side television camera assembly from the outer mirror hole cover assembly.