Home › Engine / Hybrid System › A25A-FXS (ENGINE CONTROL) › SFI SYSTEM (w/ Canister Pump Module) › from 2021.02
RM33C0E _51 Engine / Hybrid System _065419 A25A-FXS ENGINE CONTROL _0332275 SFI SYSTEM(w/ Canister Pump Module) L

A25A-FXS ENGINE CONTROL  SFI SYSTEM(w/ Canister Pump Module)  PRECAUTION  


WHEN USING GTS


CAUTION:

Observe the following items for safety reasons:


·

Before using the GTS, read the instruction manual.

·

Prevent the GTS cable from being caught on the pedals, shift lever or steering wheel when driving with the GTS connected to the vehicle.

·

When driving the vehicle for testing purposes using the GTS, 2 persons are required. One to drive the vehicle, and another to operate the GTS.



INITIALIZATION


NOTICE:
·

Perform Registration (VIN registration) after replacing the ECM.

Click hereEngine / Hybrid System>A25A-FXS (ENGINE CONTROL)>SFI SYSTEM (w/ Canister Pump Module)>REGISTRATION

·

Perform Learning Value Reset and Idle Learning after replacing or servicing parts related to engine operation.

Click hereEngine / Hybrid System>A25A-FXS (ENGINE CONTROL)>SFI SYSTEM (w/ Canister Pump Module)>INITIALIZATION

·

Perform "Grille Shutter Control Mode Switching and Grille Shutter Initialization" after replacing the radiator shutter assembly.

Click hereEngine / Hybrid System>A25A-FXS (ENGINE CONTROL)>SFI SYSTEM (w/ Canister Pump Module)>INITIALIZATION

·

When the cable is disconnected from the negative (-) auxiliary battery terminal, initialize the following system(s) after the cable is reconnected.

System Name See Procedure
Lane Tracing Assist System (Click here)
Pre-collision System
Parking Assist Monitor System
Panoramic View Monitor System




PRECAUTIONS FOR INSPECTING HYBRID CONTROL SYSTEM




NOTICE FOR HYBRID CONTROL SYSTEM ACTIVATION




PRECAUTION WHEN REPLACING BATTERY ECU ASSEMBLY AND ECM (for Lithium-ion Battery)