Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM › from 2021.02
RM33C0E _58 Vehicle Interior _065464 HEATING / AIR CONDITIONING _0329891 AIR CONDITIONING SYSTEM J

HEATING / AIR CONDITIONING  AIR CONDITIONING SYSTEM  Weak Blower Output  


DESCRIPTION

If the airflow from the front registers is weak regardless of the blower speed setting displayed on the air conditioning control assembly, the following factors may be the cause.

Symptom Factor
·

Airflow volume is constantly low

·

Airflow volume sometimes becomes low


·

Blower motor with fan sub-assembly malfunction

·

ECO mode control of air conditioning system is enabled

·

Clogged clean air filter

·

Clogged No. 1 cooler evaporator sub-assembly or heater radiator unit sub-assembly fins

·

No. 1 cooler thermistor malfunction

·

Aspirator not connected properly



PROCEDURE

1.CHECK AIR CONDITIONING SYSTEM
a.

Operate the blower switch with the following conditions met and check that the airflow volume changes.

Blower Speed Condition
LO → HI
·

Temperature setting: MAX COLD

·

Air outlet mode: FACE

·

A/C switch: Off



OK:

Airflow volume increases.



Result:
Proceed to
OK
NG



OK

2.CHECK ECO MODE CONTROL OPERATION

NG

GO TO OTHER DIAGNOSIS PROCEDURE (Blower Motor Circuit)

2.CHECK ECO MODE CONTROL OPERATION
a.

Check that ECO mode control is disabled (ECO mode indicator is not illuminated).


b.

Operate the ECO switch assembly (electric parking brake switch assembly) and check that the ECO mode indicator illuminates and the blower speed is reduced.

HINT:
·

When ECO mode control is operating, the air conditioning amplifier assembly controls the air conditioning system to enhance fuel efficiency. Therefore, explain to the customer that, when ECO mode control is operating, the blower speed will be reduced.

Control Outline
Blower Control When the air conditioning system is in AUTO mode, the blower speed will be reduced to a certain speed. Additionally, if warm-up control is operating, the blower speed will be further reduced.
Air Inlet Control If the ambient temperature is a certain value or more, the air inlet mode will be changed to recirculation mode.

·

In some situations, ECO mode control may not operate even though it is enabled.




c.

Operate the ECO switch assembly (electric parking brake switch assembly) and check that the ECO mode indicator turns off and the blower speed returns to normal.

OK:

When the ECO switch assembly (electric parking brake switch assembly) is operated, ECO mode control is enabled/disabled and the blower speed is controlled.



Result:
Proceed to
OK
NG



OK

3.CHECK CLEAN AIR FILTER

NG

3.CHECK CLEAN AIR FILTER
a.

Visually check the clean air filter.

Click hereGeneral>MAINTENANCE>AIR CONDITIONING FILTER>REMOVAL

OK:

The clean air filter is not dirty or clogged.



Result:
Proceed to
OK
NG



OK

4.CHECK NO. 1 COOLER THERMISTOR

NG

REPLACE CLEAN AIR FILTER

4.CHECK NO. 1 COOLER THERMISTOR
a.

Check the installation condition of the No. 1 cooler thermistor.

OK:

The No. 1 cooler thermistor is installed correctly.



Result:
Proceed to
OK
NG



OK

5.CHECK ASPIRATOR

NG

5.CHECK ASPIRATOR
a.

Check the installation condition of the aspirator.

OK:

The aspirator is installed correctly.



Result:
Proceed to
OK
NG



OK

REPLACE HEATER RADIATOR UNIT SUB-ASSEMBLY OR NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY

NG