Home › Engine / Hybrid System › CRUISE CONTROL › MILLIMETER WAVE RADAR SENSOR › from 2021.02
RM33C0E _51 Engine / Hybrid System _065434 CRUISE CONTROL _0331763 MILLIMETER WAVE RADAR SENSOR A

CRUISE CONTROL  MILLIMETER WAVE RADAR SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are replaced during millimeter wave radar sensor assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Millimeter wave radar sensor assembly Adjust millimeter wave radar sensor assembly
·

Dynamic Radar Cruise Control System

·

Lane Tracing Assist System

·

Road Sign Assist System

·

Front Radar Sensor System

·

Pre-collision System

·

Lighting System (EXT) (w/ Automatic Headlight Beam Level Control System)


Target Adjustment (Triangle Target):(Click here)
or
Target Adjustment (Flat Surface Target):(Click here)
or
Driving Adjustment:(Click here)

PROCEDURE

Hide 53295E 1.REMOVE COOL AIR INTAKE DUCT SEAL

Hide 88211B 2.REMOVE MILLIMETER WAVE RADAR SENSOR ASSEMBLY

a.
E453593

Disconnect the connector.


b.
E453594C01
0,0 0,0 false
V100135

Bolt
V100136

Screw


Remove the 2 bolts and screw.


c.

Disengage the 2 guides and remove the millimeter wave radar sensor assembly.

NOTICE:

Do not reuse the millimeter wave radar sensor assembly if it has been dropped or subjected to a severe impact.