Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM › from 2021.02
RM33C0E _51 Engine / Hybrid System _065434 CRUISE CONTROL _0328967 DYNAMIC RADAR CRUISE CONTROL SYSTEM C

CRUISE CONTROL  DYNAMIC RADAR CRUISE CONTROL SYSTEM  U059481  Invalid Data Received from Hybrid Powertrain Control Module Invalid Serial Data Received  


DESCRIPTION

If the hybrid vehicle control ECU assembly cannot recognize the forward recognition camera. DTC U059481 is stored.

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from
U059481 Invalid Data Received from Hybrid Powertrain Control Module Invalid Serial Data Received Approximately 17 seconds or more after the power switch is turned on (IG), the hybrid vehicle control ECU assembly cannot recognize the forward recognition camera for approximately 2 seconds or more. Hybrid vehicle control ECU assembly Radar Cruise2

CAUTION / NOTICE / HINT

NOTICE:

Before replacing the hybrid vehicle control ECU assembly, refer to Service Bulletin.


PROCEDURE

1.CHECK FOR DTC (Radar Cruise2)
a.

Clear the DTCs.

Powertrain > Radar Cruise2 > Clear DTCs
50002 426

b.

Make sure that the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the system cannot detect the malfunction.



c.

Check for DTCs.

Powertrain > Radar Cruise2 > Trouble Codes
50001 426

Result:
Result Proceed to
DTC U059481 is not output A
DTC U059481 is output B



A

B

REPLACE HYBRID VEHICLE CONTROL ECU ASSEMBLY