The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during hybrid vehicle control ECU assembly removal/installation are shown below.
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
After the power switch is turned off, the radio and display receiver assembly records various types ofmemory and settings. As a result, after turning the power switch off, make sure to wait at least 85seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.
73900
1.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (for LHD)
55308B
2.REMOVE NO. 3 INSTRUMENT PANEL TO COWL BRACE SUB-ASSEMBLY (for LHD)
64718C
3.REMOVE LUGGAGE TRIM SERVICE HOLE COVER (for RHD)
4.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL (for RHD)
67914
5.REMOVE FRONT DOOR SCUFF PLATE LH (for RHD)
62112A
6.REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH (for RHD)
62312B
7.DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP LH (for RHD)
55318C
8.REMOVE INSTRUMENT SIDE PANEL LH (for RHD)
55607
9.REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for RHD)
55435B
10.REMOVE NO. 1 METER HOOD CLUSTER (for RHD)
Use the same procedure for RHD and LHD.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>FRONT CONSOLE BOX>REMOVAL
55012A
11.REMOVE NO. 2 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY (for RHD)
Use the same procedure for RHD and LHD.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>FRONT CONSOLE BOX>REMOVAL
55476C
12.REMOVE INSTRUMENT PANEL FINISH PLATE GARNISH (for RHD)
Use the same procedure for RHD and LHD.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>FRONT CONSOLE BOX>REMOVAL
55303B
13.REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY (for RHD)
Use the same procedure for RHD and LHD.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>INSTRUMENT PANEL SAFETY PAD>REMOVAL
89980
14.REMOVE HYBRID VEHICLE CONTROL ECU ASSEMBLY
| *A | for LHD |
| *B | for RHD |
Disconnect the 4 hybrid vehicle control ECU assembly connectors.
Remove the bolt, nut and hybrid vehicle control ECU assembly.