Home › Engine / Hybrid System › CRUISE CONTROL › LANE TRACING ASSIST SYSTEM › from 2021.02
RM33C0E _51 Engine / Hybrid System _065434 CRUISE CONTROL _0465300 LANE TRACING ASSIST SYSTEM J

CRUISE CONTROL  LANE TRACING ASSIST SYSTEM  Indicator Circuit  


DESCRIPTION

The LTA indicator output request signal is sent from the forward recognition camera to the combination meter assembly via CAN communication.

CAUTION / NOTICE / HINT

NOTICE:

When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.


PROCEDURE

1.READ VALUE USING GTS (CAN BUS CHECK)
a.

Using the GTS, perform CAN bus diagnostics and check that there are no malfunctions in ECUs connected to the CAN communication system.

Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>DIAGNOSIS SYSTEM

CAN Bus Check
50007

Result:
Result Proceed to
CAN communication system is normal (DTC (CAN Communication Malfunction, ECU Communication Malfunction/Communication Lost) is not output) A
CAN communication system is malfunctioning (DTC (CAN Communication Malfunction, ECU Communication Malfunction/Communication Lost) is output) B



A

2.CHECK FOR DTCs (HEALTH CHECK)

B

2.CHECK FOR DTCs (HEALTH CHECK)
a.

Using the GTS, perform a health check.


Result:
Result Proceed to
DTCs are not output A
DTCs are output B



A

3.PERFORM ACTIVE TEST USING GTS (Combination Meter)

B

GO TO DTC CHART FOR OUTPUT DTC

3.PERFORM ACTIVE TEST USING GTS (Combination Meter)
a.

Perform the Active Test according to the display on the GTS.

Body Electrical > Combination Meter > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Multi Display All (White) Multi-information display (White display) ON Confirm that the vehicle is stopped with the power switch on (IG).
Body Electrical > Combination Meter > Active Test
Tester Display
Multi Display All (White)
50004 409 20

Result:
Result Proceed to
The multi-information display in the combination meter assembly turns on according to the Active Test A
The multi-information display in the combination meter assembly does not turn off according to the Active Test B



A

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

B

REPLACE COMBINATION METER ASSEMBLY