Home › Vehicle Interior › PRE-COLLISION › PRE-COLLISION SYSTEM › from 2021.02
RM33C0E _58 Vehicle Interior _065461 PRE-COLLISION _0332154 PRE-COLLISION SYSTEM C

PRE-COLLISION  PRE-COLLISION SYSTEM  U041881  Invalid Data Received from Brake System Control Module Invalid Serial Data Received  


DESCRIPTION

·

The forward recognition camera receives signals from the skid control ECU (brake booster with master cylinder assembly) corresponding to the brake control status via the CAN communication line.

·

When a brake control system malfunction signal is received from the skid control ECU (brake booster with master cylinder assembly), the forward recognition camera outputs U041881.


DTC No. Detection Item DTC Detection Condition Trouble Area
U041881 Invalid Data Received from Brake System Control Module Invalid Serial Data Received Once 3 seconds elapse after turning the power switch on (IG), the forward recognition camera receives a brake control system malfunction signal from the skid control ECU (brake booster with master cylinder assembly) for approximately 1 second or more.
·

Electronically controlled brake system

·

Forward recognition camera



CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the forward recognition camera, always replace it with a new one. If a forward recognition camera which was installed to another vehicle is used, the information stored in the forward recognition camera will not match the information from the vehicle. As a result, a DTC may be stored.

·

When the forward recognition camera is replaced with a new one or the windshield glass is replaced or removed/installed, make sure to read Before Starting Adjustment, then perform optical axis alignment for the forward recognition camera and clear the vehicle control history for each system.

HINT:

Forward recognition camera axis alignment can be performed by using either One Time Recognition, Sequential Recognition or Driving Adjustment.

One Time Recognition: Click hereEngine / Hybrid System>CRUISE CONTROL>FRONT CAMERA>TARGET ADJUSTMENT(ONE TIME RECOGNITION)

Sequential Recognition: Click hereEngine / Hybrid System>CRUISE CONTROL>FRONT CAMERA>TARGET ADJUSTMENT(SEQUENTIAL RECOGNITION)

Driving Adjustment: Click hereEngine / Hybrid System>CRUISE CONTROL>FRONT CAMERA>DRIVING ADJUSTMENT




PROCEDURE

1.CHECK ELECTRONICALLY CONTROLLED BRAKE SYSTEM
a.

Check the DTCs.

Chassis > ABS/VSC/TRC > Trouble Codes
50001 105
OK:

Electronically controlled brake system DTCs are not output.


HINT:

If U041881 is output in the pre-collision system, electronically controlled brake system DTCs may also have been output. Check the electronically controlled brake system first.



Result:
Proceed to
OK
NG



OK

REPLACE FORWARD RECOGNITION CAMERA

NG