46310B
1.INSPECT PARKING BRAKE ACTUATOR ASSEMBLY
Using the GTS to perform the Utilities allows relays and actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Utilities early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Utilities.
When the vehicle's tires are lifted off the ground and the GTS is used to operate the electric parking brake.
Check the condition of the rear tires.
According to the display on the tester, perform the Utility.
| Tester Display |
|---|
| EPB Control Switch |
| Tester Display | Condition of the Rear Tire |
|---|---|
| Lock | Lock |
| Release | Free |
If the result is not as specified, inspect the electric parking brake actuator.
Click hereBrake>PARKING BRAKE>ELECTRIC PARKING BRAKE ACTUATOR>INSPECTION
Turn the ignition switch ON, pull the electric parking brake switch to the lock side for 1 second and check that the parking brake indicator light (red) illuminates.
Push the electric parking brake switch to the release side for 1 second and check that the parking brake indicator light (red) turns off.
Also, check that the brake warning light / yellow (minor malfunction) does not illuminate at this time.