Home › Audio / Visual / Telematics › TELEMATICS › TELEMATICS SYSTEM (for eCall) › from 2021.02
RM33C0E _56 Audio / Visual / Telematics _078700 TELEMATICS _0387130 TELEMATICS SYSTEM(for eCall) M

TELEMATICS  TELEMATICS SYSTEM(for eCall)  REGISTRATION  


PROCEDURE

Hide 1. REGISTER VEHICLE INFORMATION

HINT:

If the telematics transceiver has been replaced, it is necessary to perform the Register Vehicle Information procedure.


a.

Enter the following menus: Body Electrical / Telematics / Utility / VIN Synchronization

Body Electrical > Telematics > Utility
Tester Display
VIN Synchronization
50005 459 8001

b.

According to the display on the GTS, perform VIN Synchronization to register the VIN to the telematics transceiver.


c.

According to the display on the GTS, read the IMEI, ICCID and VIN.


d.

Turn the ignition switch off.


e.

Turn the ignition switch to ON and wait for approximately 20 minutes.


f.

Turn the ignition switch ON and check the illumination status of the manual (SOS) switch indicators.

If the indicators illuminate in the following pattern, activation is complete: red (10 sec.), green (2 sec.), red and green together (1sec), then only green stays illuminated.

HINT:

If both the indicators (red and green) do not illuminate for 1 second, turn the ignition switch from off to ON and wait 1 minute. After that, turn the ignition switch off then back to ON and check that the indicators illuminate in the above pattern.